Search results
Results From The WOW.Com Content Network
The value for Signetics NE558 is an estimate because NE558 datasheets don't state I q at 5 V. [2] The value listed in this table was estimated by comparing the 5 V to 15 V ratio of other bipolar datasheets, then derating the 15 V parameter for the NE558 part, which is denoted by the "*". For the "Frequency max."
Exar 16550. The 16550 UART (universal asynchronous receiver-transmitter) is an integrated circuit designed for implementing the interface for serial communications.The corrected -A version was released in 1987 by National Semiconductor. [1]
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses ...
DataSheets.com is a searchable database of electronic component data sheets and purchasing information. [1] The website is intended for Design engineers and Electronics purchasing agents. [ 2 ] DataSheets.com was developed by UBM in conjunction with SiliconExpert Technologies .
Front page of a floppy disk controller data sheet (1979) A datasheet, data sheet, or spec sheet is a document that summarizes the performance and other characteristics of a product, machine, component (e.g., an electronic component), material, subsystem (e.g., a power supply), or software in sufficient detail that allows a buyer to understand what the product is and a design engineer to ...
The form comes with two worksheets, one to calculate exemptions, and another to calculate the effects of other income (second job, spouse's job). The bottom number in each worksheet is used to fill out two if the lines in the main W4 form. The main form is filed with the employer, and the worksheets are discarded or held by the employee.
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
The data sheet indicates that for a resistor of 91 kΩ at V CC =5 V the oscillator can vary between 190 kHz and 350 kHz resulting in wait times of 52.6 μs and 28.6 μs instead of 37 μs. If a display with the recommended 91 kΩ resistor is powered from 3.3 volts the oscillator will run much slower.