Search results
Results From The WOW.Com Content Network
Water from the system or holding tank is then run over or near this hot element in a pipe or tank, heating the water to a suitable temperature, then making the water hot enough to boil and become saturated steam, [1] at which point the saturated steam is transported to wherever it is needed via the steam pipes that exit the body of the electric ...
The makeup water in a 500 MWe plant amounts to perhaps 120 US gallons per minute (7.6 L/s) to replace water drawn off from the boiler drums for water purity management, and to also offset the small losses from steam leaks in the system.
In addition to the cost of the water heater, make sure to account for these additional expenses. Permits. Permits for a hot water heater replacement usually cost between $25 and $300, depending on ...
L.D. Porta gives the following equation determining the efficiency of a steam locomotive, applicable to steam engines of all kinds: power (kW) = steam Production (kg h −1)/Specific steam consumption (kg/kW h). A greater quantity of steam can be generated from a given quantity of water by superheating it.
The specific heat of the human body calculated from the measured values of individual tissues is 2.98 kJ · kg−1 · °C−1. This is 17% lower than the earlier wider used one based on non measured values of 3.47 kJ · kg−1· °C−1.
The most common type of electrode boiler pumps water from the lower part of the vessel to an internal header that has nozzles that allow the water to flow to electrodes. Generally the working pressure is maintained at 10 bar. If more pressure is needed (more steam) the controls speed up the pump to increase flow through additional nozzles.
Steam can be drawn off as required, either for driving a steam turbine or for process purposes (e.g. in chemical engineering), by opening a steam valve on top of the drum. . The pressure in the drum will fall but the reduced pressure causes more water to boil and the accumulator can go on supplying steam (while gradually reducing pressure and temperature) for some time before it has to be re-char
A feedwater heater is a power plant component used to pre-heat water delivered to a steam generating boiler. [ 1 ] [ 2 ] [ 3 ] Preheating the feedwater reduces the irreversibilities involved in steam generation and therefore improves the thermodynamic efficiency of the system. [ 4 ]