Search results
Results From The WOW.Com Content Network
Dieseling or engine run-on is a condition that can occur in spark-plug-ignited, gasoline-powered internal combustion engines, whereby the engine keeps running for a short period after being turned off, drawing fuel through the carburetor, into the engine and igniting it without a spark.
[c] These are supplementary pumps and do not replace the main, mechanical, oil pump. Electric pump as a main engine pump again will require big electric motors and it may be simply cheaper to drive directly from the engine. For e.g. BMW S65 engine's oil pump delivers ca. 45 LPM (Litres Per Minute) of oil at 5.5 bar pressure. [5]
The oil pressure idiot light lights when engine oil pressure drops below a predetermined level. The light normally appears when the vehicle ignition is turned on, but the engine is not running, as it detects no oil pressure due to the oil pump not operating (the oil pump is powered off the crankshaft, so only operates when the engine is running ...
Schematic diagram of a basic dry-sump engine lubrication system. The oil collects in sump (1), is withdrawn continuously by scavenge pump (2) and travels to the oil tank (3), where gases entrained in the oil separate and the oil cools. Gases (6) are returned to the engine sump. Pressure pump (4) forces the de-gassed and cooled oil (5) back to ...
Diesel engine runaway is an occurrence in diesel engines, in which the engine draws excessive fuel from an unintended source and overspeeds at higher RPMs, producing up to ten times the engine's rated output resulting in a catastrophic mechanical failure due to a lack of lubrication. [1]
The viscosity of oil can be ten times greater than water, increasing the energy required to pump oil for cooling, and reducing the net power output of the engine. Comparing air and water, air has vastly lower heat capacity per gram and per volume (4000) and less than a tenth the conductivity, but also much lower viscosity (about 200 times lower ...
In most steam engine designs there is a short time at the end of the return stroke of the piston when all the valves are shut and it is compressing any remaining steam. Water can be introduced from the boiler or in a cold engine, steam will condense to water on the cool walls of the cylinders and can potentially hydrolock an engine.
The engine oil pump cannot generate enough pressure to cause "pump-up". The problem is due to weak valve springs which permit float at high engine speeds. The followers attempt to take up what they see as extra clearance. As this speed is maintained, the lifter will continue to expand until the valve is held off its seat when it should be closed.