Search results
Results From The WOW.Com Content Network
The Whitcomb area rule, named after NACA engineer Richard Whitcomb and also called the transonic area rule, is a design procedure used to reduce an aircraft's drag at transonic speeds which occur between about Mach 0.75 and 1.2.
A special type of area density is called column density (also columnar mass density or simply column density), denoted ρ A or σ.It is the mass of substance per unit area integrated along a path; [1] It is obtained integrating volumetric density over a column: [2] =.
If the sides of the cube were multiplied by 2, its surface area would be multiplied by the square of 2 and become 24 m 2. Its volume would be multiplied by the cube of 2 and become 8 m 3. The original cube (1 m sides) has a surface area to volume ratio of 6:1. The larger (2 m sides) cube has a surface area to volume ratio of (24/8) 3:1.
The area rule is a corollary of the angular momentum law in the form: The resulting moment is equal to the product of twice the mass and the time derivative of the areal velocity. [ 10 ] It refers to the ray r → {\displaystyle {\vec {r}}} to a point mass with mass m .
A quantity equation, also sometimes called a complete equation, is an equation that remains valid independently of the unit of measurement used when expressing the physical quantities. [ 28 ] In contrast, in a numerical-value equation , just the numerical values of the quantities occur, without units.
A superficially related concept is the Whitcomb area rule, which states that wave drag due to volume in transonic flow depends primarily on the distribution of total cross-sectional area, and for low wave drag this distribution must be smooth. A common misconception is that the Sears–Haack body has the ideal area distribution according to the ...
This equal area rule can also be derived by making use of the Helmholtz free energy. [24] In any event the Maxwell construction derives from the Gibbs condition of material equilibrium. However, even though g f = g g {\displaystyle g_{f}=g_{g}} is more fundamental it is more abstract than the equal area rule, which is understood geometrically.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.