Search results
Results From The WOW.Com Content Network
Sixteen ohm drivers (or loudspeakers systems) would be connected to the 16-ohm tap, 8 ohm to the 8 ohm tap, etc. This is significant since the ratio between the loudspeaker impedance and the amplifier's impedance at a particular frequency provides damping (i.e., energy absorption) for the back EMF generated by a driver.
American EIA standard RS-299A specifies that (or DCR) should be at least 80% of the rated driver impedance, so an 8-ohm rated driver should have a DC resistance of at least 6.4 ohms, and a 4-ohm unit should measure 3.2 ohms minimum. This standard is voluntary, and many 8-ohm drivers have resistances of ≈5.5 ohms, and proportionally lower for ...
Power specifications require the load impedance to be specified, and in some cases two figures will be given (for instance, the output power of a power amplifier for loudspeakers will be typically measured at 4 and 8 ohms). To deliver maximum power to the load, the impedance of the driver should be the complex conjugate of the impedance of the ...
From about 1900 to the 1950s, the "lowest frequency in practical use" in recordings, broadcasting and music playback was 100 Hz. [9] When sound was developed for motion pictures, the basic RCA sound system was a single 8-inch (20 cm) speaker mounted in straight horn, an approach which was deemed unsatisfactory by Hollywood decisionmakers, who hired Western Electric engineers to develop a ...
The term loudspeaker may refer to individual transducers (also known as drivers) or to complete speaker systems consisting of an enclosure and one or more drivers.. To adequately and accurately reproduce a wide range of frequencies with even coverage, most loudspeaker systems employ more than one driver, particularly for higher sound pressure level (SPL) or maximum accuracy.
The loudspeaker's nominal load impedance (input impedance) of is usually around 4 to 8 Ω, although other impedance speakers are available, sometimes dropping as low as 1 Ω or 2 Ω. However, the impedance rating of a loudspeaker is simply a number that indicates the nominal minimum impedance of that loudspeaker over a representative portion of ...
The L pad attenuates the signal by having two separate rheostats connected in an "L" configuration (hence the name). One rheostat is connected in series with the loudspeaker and, as the resistance of this rheostat increases, less power is coupled into the loudspeaker and the loudness of sound produced by the loudspeaker decreases.
The impedance of a line input is typically around 10 kΩ. When driven by a line output's usual low impedance of 100 to 600 ohms, this forms a "bridging" connection in which most of the voltage generated by the source (the output) is dropped across the load (the input), and minimal current flows due to the load's relatively high impedance.