Search results
Results From The WOW.Com Content Network
Listed pros and cons must, as for all content, be sourced by a reference, either in the list or elsewhere in the article. (A "criticisms and defenses" list is a backwards pro and con list. The opposing side is presented first, followed by the responses of the defending side. Lists of this form seem to grow out of more contentious articles.)
First Tile Cutter Invented by Boada Brothers. The ceramic tile cutter works by first scratching a straight line across the surface of the tile with a hardened metal wheel and then applying pressure directly below the line and on each side of the line on top. Snapping pressure varies widely, some mass-produced models exerting over 750 kg.
Also known as grinding, roughing or rough grinding. These finishes are coarse in nature and usually are a preliminary finish applied before manufacturing. An example would be grinding gates off of castings, deburring or removing excess weld material. It is coarse in appearance and applied by using 36–100 grit abrasive. [5]
Surface grinding is done on flat surfaces to produce a smooth finish. It is a widely used abrasive machining process in which a spinning wheel covered in rough particles ( grinding wheel ) cuts chips of metallic or nonmetallic substance from a workpiece, making a face of it flat or smooth.
Metal burr extending beyond the edge of the cut piece, view on the cut face (top) and from the bottom (bottom) A burr is a raised edge or small piece of material that remains attached to a workpiece after a modification process. [1] It is usually an unwanted piece of material and is removed with a deburring tool in a process called deburring.
Grinding is a subset of cutting, as grinding is a true metal-cutting process. Each grain of abrasive functions as a microscopic single-point cutting edge (although of high negative rake angle), and shears a tiny chip that is analogous to what would conventionally be called a "cut" chip (turning, milling, drilling, tapping, etc.) [citation needed].
Grog, also known as firesand and chamotte, is a raw material usually made from crushed and ground potsherds, reintroduced into crude clay to temper it before making ceramic ware. It has a high percentage of silica and alumina. It is normally available as a powder or chippings, and is an important ingredient in Coade stone.
Conservation and restoration of ceramic objects is a process dedicated to the preservation and protection of objects of historical and personal value made from ceramic. Typically, this activity of conservation-restoration is undertaken by a conservator-restorer , especially when dealing with an object of cultural heritage .