Search results
Results From The WOW.Com Content Network
slew rate effect on a square wave: red=desired output, green=actual output. In electronics and electromagnetics, slew rate is defined as the change of voltage or current, or any other electrical or electromagnetic quantity, per unit of
Modern high-speed op amps can have slew rates in excess of 5,000 V per microsecond. However, it is more common for op amps to have slew rates in the range 5–100 V per microsecond. For example, the general purpose TL081 op amp has a slew rate of 13 V per microsecond. As a general rule, low power and small bandwidth op amps have low slew rates.
For transistors, the current-gain–bandwidth product is known as the f T or transition frequency. [4] [5] It is calculated from the low-frequency (a few kilohertz) current gain under specified test conditions, and the cutoff frequency at which the current gain drops by 3 decibels (70% amplitude); the product of these two values can be thought of as the frequency at which the current gain ...
Slew rate is the maximum rate of change of the output, usually quoted in volts per second (or microsecond). Many amplifiers are ultimately slew rate limited (typically by the impedance of a drive current having to overcome capacitive effects at some point in the circuit), which sometimes limits the full power bandwidth to frequencies well below ...
Related measurements are slew rate and rise time. Distortion in transient response can be hard to measure. Distortion in transient response can be hard to measure. Many otherwise good power amplifier designs have been found to have inadequate slew rates, by modern standards.
This is also sometimes described as the slew-rate-limited bandwidth. The full-power bandwidth B W {\displaystyle BW} is then related to the slew rate S R {\displaystyle SR} in volts per second and the peak-to-peak voltage swing V a m p {\displaystyle V_{amp}} by
Saturation occurs when the differential input voltage is too high for the op-amp's gain, driving the output level to that peak value. Slewing — the amplifier's output voltage reaches its maximum rate of change. Measured as the slew rate, it is usually specified in volts per microsecond. When slewing occurs, further increases in the input ...
This circuit has the benefit that the op-amp never goes into saturation, but its output must change by two diode voltage drops (about 1.2 V) each time the input signal crosses zero. Hence, the slew rate of the opamp and its frequency response ( gain–bandwidth product ) will limit high-frequency performance, especially for low signal levels ...