Ads
related to: 383 chrysler engine specs for sale ebay by owner
Search results
Results From The WOW.Com Content Network
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5] It was one of the last carbureted car/truck engines built in North America. [6] Chrysler never used this engine in any other vehicle.
For 1970 and 1971, the Barracuda and Barracuda Gran Coupe had two slant I6 engines available — a new 198 cu in (3.2 L) version and the previous 225 — as well as four V8 options: the 318 CID, the 383 with a two-barrel carburetor and single exhaust, the 383 cu in (6.3 L) with a four-barrel and dual exhausts, and the 383 Magnum with a four ...
Chrysler used a 14 mm (0.55 in) spark plug, rather than the typical 18 mm (0.71 in), in an effort to fit it as centrally as possible in the combustion chamber. [ 1 ] The intake and exhaust valves were the same size as the 426's, [ 6 ] the 2.25 in (57 mm) intake canted at 15° from the bore centerline, the 1.94 in (49 mm) exhaust at 6°. [ 6 ]
The Coronet R/T was available as a two-door hardtop or convertible. The standard engine was Chrysler's largest, the 440 cu in (7.2 L) V8 producing 375 bhp and dubbed the Magnum. The only engine option was the 426-cid Hemi, now in its second year in "Street" trim and again rated at 425 bhp. It was a $908 option.
The Polyspheric engines were V8 engines produced by Chrysler from 1955 to 1958 as lower-cost alternatives to its Hemi engines. [1] These engines were based on the Hemi engines, using the same blocks and crankshaft parts, but completely different cylinder heads, pushrods, exhaust manifolds and pistons.
The Chrysler flathead engine is a flathead inline automotive engine manufactured by the Chrysler Corporation from 1924 through the early 1960s. It came in four-,six-, and eight-cylinder configurations and varying displacements, with both cast iron and cast aluminum cylinder heads. It was installed in Chrysler, DeSoto, Dodge, and Plymouth ...
All C-V8s used big-block engines sourced from Chrysler; first the 361 and then, from 1964, the 330 bhp (246 kW) 383 in³. Most of the cars had three-speed Chrysler Torqueflite automatic transmission, but seven Mk2 C-V8s were produced with the 6-litre engine and four-speed manual gearbox, followed by two manual Mk3s. The engine is entirely set ...