Ad
related to: telemetry in water systems pdf
Search results
Results From The WOW.Com Content Network
In 1906 a set of seismic stations were built with telemetering to the Pulkovo Observatory in Russia. In 1912, Commonwealth Edison developed a system of telemetry to monitor electrical loads on its power grid. The Panama Canal (completed 1913–1914) used extensive telemetry systems to monitor locks and water levels. [11]
Worldwide Industrial Telemetry Standards (WITS) is a suite of communications protocols designed for use within the public utility industry between components of a SCADA system. It was developed for communications between a WITS Master Station and its remotely connected WITS Field Devices (for example, Remote Telemetry Units ).
There are both two-way RF systems and one-way RF systems in use that use both licensed and unlicensed RF bands. In a two-way or "wake up" system, a radio signal is normally sent to an AMR meter's unique serial number, instructing its transceiver to power-up and transmit its data. The meter transceiver and the reading transceiver both send and ...
A remote terminal unit (RTU) is a microprocessor-controlled electronic device that interfaces objects in the physical world to a distributed control system or SCADA (supervisory control and data acquisition) system by transmitting telemetry data to a master system, and by using messages from the master supervisory system to control connected objects. [1]
Water metering is the practice of measuring water use. Water meters measure the volume of water used by residential and commercial building units that are supplied with water by a public water supply system. They are also used to determine flow through a particular portion of the system.
Connections to the sewers (underground pipes, or aboveground ditches in some developing countries) are generally found downstream of the water consumers, but the sewer system is considered to be a separate system, rather than part of the water supply system. Water supply networks are often run by public utilities of the water industry.
The dam monitoring system checks the level of the water because this creates different pressures on the dam, also in relation to the air and water temperature. All these parameters are controlled and compared with the deformation and stress applied on the structure of the dam, measured with extensimeter, pendulum, reverse pendulum, piezometer, etc.
The first routine measurements of river flow in England began on the Thames and Lea in the 1880s, [2] and in Scotland on the River Garry in 1913. [3] The national gauging station network was established in its current form by the early 1970s and consists of approximately 1500 flow measurement stations supplemented by a variable number of temporary monitoring sites. [2]