Search results
Results From The WOW.Com Content Network
A jib or jib arm is the horizontal or near-horizontal beam used in many types of crane to support the load clear of the main support. [1] [2] An archaic spelling is gib. [3] Usually jib arms are attached to a vertical mast or tower or sometimes to an inclined boom.
Designed by the self-taught civil engineer Wendel Bollman in 1871, this truss bridge is the last remaining span of the Pittsburgh Division line associated with Bollman. Around 1931, it was moved from Wills Creek to a location 1.5 miles (2.4 km) north of Meyersdale, Pennsylvania, after it was no longer able to safely carry heavier modern ...
Side-view of Super-PostPanamax portainer crane at the APM Terminal in the Port of Rotterdam. A gantry crane is a crane built atop a gantry, which is a structure used to straddle an object or workspace. They can range from enormous "full" gantry cranes, capable of lifting some of the heaviest loads in the world, to small shop cranes, used for ...
An overhead crane, commonly called a bridge crane, is a type of crane found in industrial environments. An overhead crane consists of two parallel rails seated on longitudinal I-beams attached to opposite steel columns by means of brackets. The traveling bridge spans the gap. A hoist, the lifting component of a crane, travels along the bridge.
A telescopic mobile crane with truss luffing jib. A telescopic crane has a boom that consists of a number of tubes fitted one inside the other. A hydraulic cylinder or other powered mechanism extends or retracts the tubes to increase or decrease the total length of the boom. These types of booms are often used for short term construction ...
A gin pole in use loading logs A gin pole used to install a weather vane atop the 200-foot steeple of a church Roof trusses being assembled with gin poles. A gin pole is a mast supported by one or more guy-wires that uses a pulley or block and tackle mounted on its upper end to lift loads. The lower end is braced or set in a shallow hole and ...
In 1959 crane expert R.H.Neal, hydraulics specialist F.Taylor, and design director Bob Lester, integrated all three and modernized cranes. The Coles Hydra Speedcrane appeared in 1962, further modified with the 10-ton fully telescopic hydraulic boom in 1966, followed in 1968 by the 30-ton "Husky" military versions with four-wheel drive .
A single girder EOT crane has one main girder, making it easy to install, and requires less maintenance. The most common single girder EOT cranes are as follows: LD type single girder EOT crane; LDP type single girder EOT crane and; HD type single girder EOT crane; It is used for lighter industrial applications as it has lower weight limits.