Search results
Results From The WOW.Com Content Network
The large-journal connecting rods were thicker (heavier) and used 3 ⁄ 8 in (9.5 mm) diameter cap-bolts to replace the small-journal's 11/32. 1968 blocks were made in 2-bolt and 4-bolt versions with the 4-bolt center-three main caps each fastened by two additional bolts which were supported by the addition of thicker crankcase main-web bulkheads.
Also called the GM small corporate pattern and the S10 pattern. This pattern has a distinctive odd-sided hexagonal shape. Rear wheel drive applications have the starter mounted on the right side of the block (when viewed from the flywheel) and on the opposite side of the block compared to front wheel drive installations.
A long block does not include the fuel system, electrical, intake, and exhaust components, as well as other components. A long block may include the balancer/damper, timing cover, oil pan and valve covers. [5] A long block engine replacement typically requires swapping out parts from the original engine to the long block.
The architecture of the LS series makes for an extremely strong engine block with the aluminum engines being nearly as strong as the iron generation I and II engines. The LS engine also used coil-near-plug style ignition to replace the distributor setup of all previous small-block based engines.
A distributor consists of a rotating arm ('rotor') that is attached to the top of a rotating 'distributor shaft'. The rotor constantly receives high-voltage electricity from an ignition coil via brushes at the centre of the rotor. As the rotor spins, its tip passes close to (but does not touch) the output contacts for each cylinder.
All generation-2 small-block Olds V8s used the same stroke of 3.385 in (86 mm). The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material ...
The Chevrolet small-block engine refers to one of the several gasoline-powered vehicle engines manufactured by General Motors. These include: The first or second generation of non-LS Chevrolet small-block engines; The third, fourth, or fifth generation of LS-based GM engines; The Chevrolet Gemini small-block engine
Chevrolet (/ ˌ ʃ ɛ v r ə ˈ l eɪ / SHEV-rə-LAY), colloquially referred to as Chevy, is an American automobile division of the manufacturer General Motors (GM).. Louis Chevrolet (1878–1941), Arthur Chevrolet (1884–1946) and ousted General Motors founder William C. Durant (1861–1947) started the company on November 3, 1911 [2] as the Chevrolet Motor Car Company.