Search results
Results From The WOW.Com Content Network
My traceroute, originally named Matt's traceroute (MTR), is a computer program that combines the functions of the traceroute and ping programs in one network diagnostic tool. [ 2 ] MTR probes routers on the route path by limiting the number of hops individual packets may traverse, and listening to responses of their expiry.
Packet Tracer is commonly used by NetAcad students, since it is available to download after creating a free account. [10] However, due to functional limitations, it is intended by Cisco to be used only as a learning aid, not a replacement for Cisco routers and switches . [ 9 ]
The round-trip time or ping time is the time from the start of the transmission from the sending node until a response (for example an ACK packet or ping ICMP response) is received at the same node. It is affected by packet delivery time as well as the data processing delay , which depends on the load on the responding node.
ping is a computer network administration software utility used to test the reachability of a host on an Internet Protocol (IP) network. It is available in a wide range of operating systems – including most embedded network administration software.
This time delay includes propagation times for the paths between the two communication endpoints. [1] In the context of computer networks, the signal is typically a data packet. RTT is commonly used interchangeably with ping time, which can be determined with the ping command.
The time-to-live (TTL) value, also known as hop limit, is used in determining the intermediate routers being traversed towards the destination. Traceroute sends packets with TTL values that gradually increase from packet to packet, starting with TTL value of one.
End-to-end delay or one-way delay (OWD) refers to the time taken for a packet to be transmitted across a network from source to destination. It is a common term in IP network monitoring, and differs from round-trip time (RTT) in that only path in the one direction from source to destination is measured.
If a packet is sent to 203.0.113.1 by a computer at 192.168.1.100, the packet would normally be routed to the default gateway (the router) [e] A router with the NAT loopback feature detects that 203.0.113.1 is the address of its WAN interface, and treats the packet as if coming from that interface. It determines the destination for that packet ...