Search results
Results From The WOW.Com Content Network
This page describes how to set up a local instance of reFill on Windows 10 or Windows 11.Once set up, the instance can be used to process bare URLs, to understand the reFill project's architecture and code, or to develop bug fixes and enhancements. reFill was developed using open source software and the Linux stack, and the instructions for building an instance for those who are comfortable ...
A Direct Cable Connection dialog box on Windows 95. Direct Cable Connection (DCC) is a feature of Microsoft Windows that allows a computer to transfer and share files (or connected printers) with another computer, via a connection using either the serial port, parallel port or the infrared port of each computer.
The N 2 chart or N 2 diagram (pronounced "en-two" or "en-squared") is a chart or diagram in the shape of a matrix, representing functional or physical interfaces between system elements. It is used to systematically identify, define, tabulate, design, and analyze functional and physical interfaces.
It is generally accepted that RS-485 can be used with data rates up to 10 Mbit/s [a] or, at lower speeds, distances up to 1,200 m (4,000 ft). [2] As a rule of thumb, the speed in bit/s multiplied by the length in meters should not exceed 10 8. Thus a 50-meter cable should not signal faster than 2 Mbit/s. [3]
[1] [2] A single line in the diagram typically corresponds to more than one physical conductor: in a direct current system the line includes the supply and return paths, in a three-phase system the line represents all three phases (the conductors are both supply and return due to the nature of the alternating current circuits).
It is very similar to full-bandwidth operation except each bit takes 8 times as long to transmit. It is intended primarily to save cost in low-bandwidth human interface devices (HID) such as keyboards, mice, and joysticks. Full speed (FS) rate of 12 Mbit/s is the basic USB signaling rate defined by USB 1.0. All USB hubs can operate at this rate.
In electronic design, wire routing, commonly called simply routing, is a step in the design of printed circuit boards (PCBs) and integrated circuits (ICs). It builds on a preceding step, called placement , which determines the location of each active element of an IC or component on a PCB.
The wire protocol may be either text-based or a binary protocol. Although an important architectural decision, this is a separate matter from the distinction between wire protocols and programmatic APIs. In electronics, a wire protocol is the mechanism used to transmit data from one point to another. [1]