Search results
Results From The WOW.Com Content Network
Since those days, lift, velocity, acceleration, and jerk curves for cams have been modelled by computer [6] to reveal that cam dynamics are not what they seemed. With proper analysis, problems relating to valve adjustment, hydraulic tappets, push rods, rocker arms, and above all, valve float, became things of the past without desmodromic drive.
Pushrods are long, slender metal rods that are used in overhead valve engines to transfer motion from the camshaft (located in the engine block) to the valves (located in the cylinder head). The bottom end of a pushrod is mated to a lifter , upon which the camshaft makes contact.
The main difference was that instead of the push rod passing directly from the engine to the gun itself, which would have required a tunnel through the firewall and fuel tank (as shown in the Saulnier patent drawings), it was driven by a shaft joining the oil pump to a small cam at the top of the fuselage.
Smaller overall packaging: The cam-in-block design of an OHV engine results in a smaller overall size, compared with an equivalent OHC engine, which can have some advantages in center of gravity and hood height in V-engine designs. [16] Simpler camshaft drive system: OHV engines have a less complex drive system for the camshaft than OHC engines ...
This page was last edited on 1 April 2015, at 17:06 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may ...
The cam can be seen as a device that converts rotational motion to reciprocating (or sometimes oscillating) motion. [clarification needed] [3] A common example is the camshaft of an automobile, which takes the rotary motion of the engine and converts it into the reciprocating motion necessary to operate the intake and exhaust valves of the cylinders.
A connecting rod, also called a 'con rod', [1] [2] [3] is the part of a piston engine which connects the piston to the crankshaft. Together with the crank, the connecting rod converts the reciprocating motion of the piston into the rotation of the crankshaft. [4] The connecting rod is required to transmit the compressive and tensile forces from ...
However, these generally have the roller at the point where the cam lobe contacts the rocker, rather than where the rocker contacts the valve stem. Some OHC engines employ short rocker arms, also known as finger followers, [2] in which the cam lobe pushes downward on the back of the rocker arm to open the valve. In such a configuration one end ...