Ads
related to: so 239 bulkhead feed through
Search results
Results From The WOW.Com Content Network
The connector reliably carries signals at frequencies up to 100 MHz. [1] The coupling shell has a 5 / 8 inch 24 tpi UNEF standard thread. [4] The most popular cable plug and corresponding chassis-mount socket carry the old Signal Corps labels PL-259 (plug #259) and SO-239 (socket #239). [12]
A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...
A feedthrough is a conductor used to carry a signal through an enclosure or printed circuit board. Like any conductor, it has a small amount of capacitance . A "feedthrough capacitor" has a guaranteed minimum value of shunt capacitance [ clarify ] built in it and is used for bypass purposes in ultra-high-frequency applications. [ 1 ]
Most passenger vehicles and some freight vehicles will have a bulkhead which separates the engine compartment from the passenger compartment or cab; [11] the automotive use is analogous to the nautical term in that the bulkhead is an internal wall which separates different parts of the vehicle. Some passenger vehicles (particularly sedan/saloon ...
A vestibule is composed of an ACBM ring (1) mounted to a flanged bulkhead (3) and a PCBM ring (2) mounted to a flanged bulkhead or barrel section (4). The rings, both machined from 2219 Aluminum forgings, mate at a "molded seal" (5); each ring is sealed at its inboard end by a pair of concentric o-rings (6).
A bulkhead is a flatcar with walls on the front and rear. A center-beam bulkhead is a bulkhead flatcar with an additional wall dividing one side of the flatcar from the other, but still without any sides. [104] Flatback Industry slang for trailer-on-flatcar service in the 1970s, especially in the trade journal Railway Age [113] Foamer
In analog electronics, Clock feedthrough is the result of the coupling between control signals on the analog switch and analog signal passing through the switch. In digital electronics, clock feedthrough is the coupling of the clock signal to the nodes where coupling is not intended.
The feed-through nuller samples the bleed-through signal arriving at the receiver. This bleed-through sample is amplified, filtered (low-pass), and this is used to drive the attenuator. Attenuator output is phase shifted 180 degrees added to the receive signal. This cancels the bleed-through signal. Total gain determines the amount of cancellation.