Ads
related to: decorative wood outside corner molding 2 inch metal pipe
Search results
Results From The WOW.Com Content Network
Keel moulding : Sharp-edged moulding resembling a cross-section of a ship's keel, common in the Early English and Decorated styles. [8] Lamb's tongue : Lambs Tongue is a moulding having a deep, symmetrical profile ending in a narrow edge. [9] Muntin: Narrow strip of wood or metal separating and holding panes of glass in a window. Ogee: see "Cyma"
A building's surface detailing, inside and outside, often includes decorative moulding, and these often contain ogee-shaped profiles—consisting (from low to high) of a concave arc flowing into a convex arc, with vertical ends; if the lower curve is convex and higher one concave, this is known as a Roman ogee, although frequently the terms are used interchangeably and for a variety of other ...
A compound crown molding built up out of several individual trim elements Decorative pilaster of natural cherry hardwood topped with crown molding Crown molding may be a complex build-up of multiple trim elements, in this case built-out slightly above a window with short 90-degree returns The relief on this short 90-degree return of crown molding was back-cut with a coping saw
It is an engineered wood product manufactured from refined wood fibers combined with wax and resin binders. MDF is denser and more rigid than standard particle board. Compared to solid wood trim, MDF baseboard has the advantage of being consistent in thickness and profile. It resists warping, swelling, and shrinking that can occur with natural ...
Studs usually consist of 1 + 1 ⁄ 2-by-3 + 1 ⁄ 2-inch (38 mm × 89 mm) or 1 + 1 ⁄ 2-by-5 + 1 ⁄ 2-inch (38 mm × 140 mm) lumber and are commonly spaced at 16 inches (410 mm) on center. This spacing may be changed to 12 or 24 inches (300 or 610 mm) on center depending on the load and the limitations imposed by the type and thickness of the ...
The staff bead, a 1-inch dowel with approx 1 ⁄ 3 shaved off the back, is set on the external corner by the joiner on site, fastened to wooden plugs set into the brick/block seams, or to the wood frame. Plaster is run up to the staff bead and then cut back locally to the bead or "quirked" to avoid a weak feather edge where the plaster meets ...