Ads
related to: 1 2 hex shaft coupler wrench chart
Search results
Results From The WOW.Com Content Network
The tolerances necessary to make the tools usable are listed in documents such as ASME/ANSI B18.2.2 for U.S. standards. [1] For instance, a bolt for a 1-inch nominal diameter thread might have flats that are 1.5 inches apart. The wrench for this bolt should have flats that are between 1.508 and 1.520 inches apart to allow for a little extra space.
A coupling nut A coupling nut and its orthographic view. A coupling nut, also known as extension nut, is a threaded fastener for joining two male threads, most commonly a threaded rod, [1] [2] but also pipes. [3] The outside of the fastener is usually hexagonal so a wrench can hold it.
The hex socket screw drive has a hexagonal recess and may be driven by a hex wrench, also known as an Allen wrench, Allen key, hex key, or inbus as well as by a hex screwdriver (also known as a hex driver) or bit. Tamper-resistant versions with a pin in the recess are available.
An ASME B18.2.1 compliant cap screw has somewhat tighter tolerances than a hex bolt for the head height and the shank length. The nature of the tolerance difference allows an ASME B18.2.1 hex cap screw to always fit where a hex bolt is installed but a hex bolt could be slightly too large to be used where a hex cap screw is designed in.
This is the most common size and takes a hammer up to 4 kg. The wedges grip an area of 75 mm 2 (0.116 sq in) and the shank is inserted 40 mm into the chuck. SDS-top A 14 mm shank similar to SDS-plus, designed for hammers from 2 to 5 kg. The grip area is increased to 212 mm 2 (0.329 sq in) and the shank is inserted 70 mm. This size remained ...
There are many variations in the design of quick couplers. The initial divergence is between those that can pick up any of a range of buckets and attachments by clamping onto the mounting pins for the attachment (known as "pin grabbers" or "pin couplers") and those that work only with buckets and attachments designed to suit that quick coupler (known as "dedicated").
A common type of this style fitting is a "hex bushing" with a hex head for installation with a pipe wrench. A double-tapped bushing is more compact than a reducer but not as flexible. While a double-tapped bushing has a more minor female thread concentric to a larger male thread (and thus couples a smaller male end to a larger female), a ...
A spinner handle is a shaft and handle with a drive fitting—most commonly 1 ⁄ 4 in (6.35 mm) square axle at the end for attaching interchangeable sockets. This allows one to use a single handle with a number of sizes instead of having a separate nut driver for each size.