Search results
Results From The WOW.Com Content Network
Typical push–pull audio tube power amplifier, matched to loudspeaker with an impedance-matching transformer. Audio amplifiers typically do not match impedances, but provide an output impedance that is lower than the load impedance (such as < 0.1 ohm in typical semiconductor amplifiers), for improved speaker damping.
The amplifier damping factor, which is the ratio of the nominal load impedance (driver voice coil) to amplifier output impedance, is adequate in either case for well-designed solid state amplifiers. Tube amplifiers have sufficiently higher output impedances that they normally included multi-tap output transformers to better match to the driver ...
The L pad attenuates the signal by having two separate rheostats connected in an "L" configuration (hence the name). One rheostat is connected in series with the loudspeaker and, as the resistance of this rheostat increases, less power is coupled into the loudspeaker and the loudness of sound produced by the loudspeaker decreases.
Line level is the specified strength of an audio signal used to transmit analog sound between audio components such as CD and DVD players, television sets, audio amplifiers, and mixing consoles. Generally, line level signals sit in the middle of the hierarchy of signal levels in audio engineering.
Audio power is the electrical power transferred from an audio amplifier to a loudspeaker, measured in watts. The electrical power delivered to the loudspeaker, together with its efficiency , determines the sound power generated (with the rest of the electrical power being converted to heat).
Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...
A single amplifier can usually power a woofer and a tweeter only through a post-amplifier crossover filter, which protects each driver from signals outside its frequency range. Bi-amping of speakers requires double the channels of amplification and can be accomplished using two ordinary amplifiers in either a vertical or horizontal arrangement.
A lower damping factor helps to enhance the bass response of the loudspeaker by several decibels (where the impedance of the speaker would be at its maximum), which is useful if only a single speaker is used for the entire audio range. Therefore, some amplifiers, in particular vintage amplifiers from the 1950s, 1960s and 1970s, feature controls ...