Search results
Results From The WOW.Com Content Network
The motor speed varies as a non-linear function of load torque and armature current; current is common to both the stator and rotor yielding current squared (I^2) behavior [citation needed]. A series motor has very high starting torque and is commonly used for starting high inertia loads, such as trains, elevators or hoists. [2]
The universal motor is a type of electric motor that can operate on either AC or DC power and uses an electromagnet as its stator to create its magnetic field. [1] It is a commutated series-wound motor where the stator's field coils are connected in series with the rotor windings through a commutator. It is often referred to as an AC series motor.
An output filter is sometimes installed to smooth the average voltage applied to the motor and reduce motor noise. Since the series-wound DC motor develops its highest torque at low speed, it is often used in traction applications such as electric locomotives, and trams. Another application is starter motors for petrol and small diesel engines.
A further measure of control is provided by using pairs of motors on a vehicle in series-parallel control; for slow operation or heavy loads, two motors can be run in a series of the direct-current supply. Where higher speed is desired, these motors can be operated in parallel, making a higher voltage available at each motor and so allowing ...
The J-series engine was designed in the United States by Honda engineers. It is built at Honda's Anna, Ohio, and Lincoln, Alabama, engine plants. The J-series is a 60° V6 unlike Honda's existing 90° C-series engines. Also unlike the C series, the J-series was specifically and only designed for transverse mounting.
Series circuits were formerly used for lighting in electric multiple units trains. For example, if the supply voltage was 600 volts there might be eight 70-volt bulbs in series (total 560 volts) plus a resistor to drop the remaining 40 volts. Series circuits for train lighting were superseded, first by motor-generators, then by solid state devices.
Starter motor diagram. The electric starter motor or cranking motor is the most common type used on gasoline engines and small diesel engines. The modern starter motor is either a permanent-magnet or a series-parallel wound direct current electric motor with a starter solenoid (similar to a relay) mounted on it.
A stepper motor, also known as step motor or stepping motor, [1] is a brushless DC electric motor that rotates in a series of small and discrete angular steps. [2] Stepper motors can be set to any given step position without needing a position sensor for feedback. The step position can be rapidly increased or decreased to create continuous ...