When.com Web Search

  1. Ads

    related to: wood stove vent pipe roof flashing

Search results

  1. Results From The WOW.Com Content Network
  2. Chimney - Wikipedia

    en.wikipedia.org/wiki/Chimney

    On a pitched roof where a chimney penetrates a roof, flashing is used to seal up the joints. The down-slope piece is called an apron, the sides receive step flashing and a cricket is used to divert water around the upper side of the chimney underneath the flashing. [6]

  3. Flashing (weatherproofing) - Wikipedia

    en.wikipedia.org/wiki/Flashing_(weatherproofing)

    Pipe flashing (pipe boot, vent boot, pipe flange) A product used where pipes penetrate roofs. Chimney flashing A general term for flashing a chimney to cover the intersections of the chimney and install a damp proof course (DPC) Kickout flashing At the very bottom of a roof/wall intersection, the lowermost step flashing specially formed to ...

  4. Direct vent fireplace - Wikipedia

    en.wikipedia.org/wiki/Direct_vent_fireplace

    The flue system is composed of two flues, the inner flue and the outer flue. The outer flue draws air into the bottom of the sealed firebox to allow for combustion. The inner flue draws hot exhaust gasses from the top of the sealed firebox and vents them directly to the outside of the structure through either an adjacent wall or roof.

  5. Flue - Wikipedia

    en.wikipedia.org/wiki/Flue

    A flue is a duct, pipe, or opening in a chimney for conveying exhaust gases from a fireplace, furnace, water heater, boiler, or generator to the outdoors. Historically the term flue meant the chimney itself. [1] In the United States, they are also known as vents for boilers and as breeching for water heaters and modern furnaces.

  6. Reglet - Wikipedia

    en.wikipedia.org/wiki/Reglet

    A reglet is found on the exterior of a building along a masonry wall, chimney or parapet that meets the roof. It is a groove cut within a mortar joint that receives counter-flashing meant to cover surface flashing used to deflect water infiltration. Reglet can also refer to the counter-flashing itself when it is applied on the surface, known as ...

  7. Heat and smoke vent - Wikipedia

    en.wikipedia.org/wiki/Heat_and_smoke_vent

    The majority of guidance available for design of heat and smoke building vents installed in buildings is restricted to nonsprinklered, single-story buildings. [4] This is partly a historical consequence of the installation of heat and smoke vents following the August 1953 General Motors, Livonia, MI major fire in a nonsprinklered manufacturing facility which effectively stopped the production ...