Ads
related to: half wave end fed wire antenna calculator
Search results
Results From The WOW.Com Content Network
A half-wave dipole antenna consists of two quarter-wavelength conductors placed end to end for a total length of approximately ℓ = 1 / 2 λ. The current distribution is that of a standing wave , approximately sinusoidal along the length of the dipole, with a node at each end and an antinode (peak current) at the center (feedpoint ...
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
The angle of the slope is usually between 45°–60° and the lower end of the wire is at least 1 ⁄ 6 wavelength above the electrical ground. [3] A sloper is typically fed with a coaxial cable in the center, at the top of the center support mast. At least 1 ⁄ 4 of the wavelength of feedline must be at 90° angle to the antenna. [3]
Simulating the end-fed half-wave (EFHW) dipole antenna VK3IL - Multiband end-fed 80-10m antenna - NEC2 model file of a "MyAntennas EFHW-8010 " multi-band antenna. Other retail books (such as The ARRL Antenna Book, Marcel De Canck's Advanced Antenna Modeling, and others) also include antenna model files.
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.
A dipole can be fed from very near its end (needing to be only about 1 / 20 th of the dipole length from the actual end) but the end impedances are exceedingly high – a few thousands of ohms, depending on the average height of the antenna and thickness of its wire.
When the antenna is fed at a point of maximum current, as in the common center-fed half-wave dipole or base-fed quarter-wave monopole, that value is mostly the radiation resistance. However, if the antenna is fed at some other point, the equivalent radiation resistance at that point R r a d 1 {\displaystyle \ R_{\mathsf {rad\ 1}}\ } can easily ...
A Yagi–Uda antenna, or simply Yagi antenna, is a directional antenna consisting of two or more parallel resonant antenna elements in an end-fire array; [1] these elements are most often metal rods (or discs) acting as half-wave dipoles. [2] Yagi–Uda antennas consist of a single driven element connected to a radio transmitter or receiver (or ...