Search results
Results From The WOW.Com Content Network
Example 1: If a block of solid stone weighs 3 kilograms on dry land and 2 kilogram when immersed in a tub of water, then it has displaced 1 kilogram of water. Since 1 liter of water weighs 1 kilogram (at 4 °C), it follows that the volume of the block is 1 liter and the density (mass/volume) of the stone is 3 kilograms/liter.
By measuring the level of water remaining in the vessel, the time can be measured with uniform graduation. This is an example of outflow clepsydra. Since the water outflow rate is higher when the water level is higher (due to more pressure), the fluid's volume should be more than a simple cylinder when the water level is high.
Some SI units of volume to scale and approximate corresponding mass of water. To ease calculations, a unit of volume is equal to the volume occupied by a unit cube (with a side length of one). Because the volume occupies three dimensions, if the metre (m) is chosen as a unit of length, the corresponding unit of volume is the cubic metre (m 3).
Measurement of volume by displacement, (a) before and (b) after an object has been submerged. The amount by which the liquid rises in the cylinder (∆V) is equal to the volume of the object. In fluid mechanics, displacement occurs when an object is largely immersed in a fluid, pushing it out of the way and taking its place. The volume of the ...
The ship's hydrostatic tables show the corresponding volume displaced. [4] To calculate the weight of the displaced water, it is necessary to know its density. Seawater (1,025 kg/m 3) is more dense than fresh water (1,000 kg/m 3); [5] so a ship will ride higher in salt water than in fresh. The density of water also varies with temperature.
The total volume of the tank is V t. Case 2 is a tank in use, with the air pressure at pressure P (gauge) and a water volume of V. Referring to the diagram on the right, a pressure tank is generally pressurized when empty with a "charging pressure" P c, which is usually about 2 psi below the turn-on pressure P lo (Case 1).
An elevated water tank, also known as a water tower, will create a pressure at the ground-level outlet of 1 kPa per 10.2 centimetres (4.0 in) or 1 psi per 2.31 feet (0.70 m) of elevation. Thus a tank elevated to 20 metres creates about 200 kPa and a tank elevated to 70 feet creates about 30 psi of discharge pressure, sufficient for most ...
It consists of the tank and a septic drain field. Waste water enters the tank where solids can settle and scum floats. Anaerobic digestion occurs on the settled solids, reducing the volume of solids. The water released by the system is normally absorbed by the drain field without needing any further treatment.