Search results
Results From The WOW.Com Content Network
The power of an AM radio signal plotted against frequency. fc is the carrier frequency, fm is the maximum modulation frequency. In radio communications, a sideband is a band of frequencies higher than or lower than the carrier frequency, that are the result of the modulation process. The sidebands carry the information transmitted by the radio ...
In the fields of nonlinear optics and fluid dynamics, modulational instability or sideband instability is a phenomenon whereby deviations from a periodic waveform are reinforced by nonlinearity, leading to the generation of spectral-sidebands and the eventual breakup of the waveform into a train of pulses.
A side band or sideband can refer to: Side project , in music Sideband , in communications, either of the two bands of frequencies, one just above and one just below a carrier frequency, that result from modulation of a carrier wave
The carrier frequency is 1.25 MHz above the lower edge of the 6 MHz wide channel. This effectively makes the system AM at low modulation frequencies and SSB at high modulation frequencies. The absence of the lower sideband components at high frequencies must be compensated for, and this is done in the IF amplifier.
The zero-phonon line is located at a frequency ω’ determined by the intrinsic difference in energy levels between ground and excited state as well as by the local environment. The phonon sideband is shifted to a higher frequency in absorption and to a lower frequency in fluorescence.
Independent sideband (ISB) is an AM single sideband mode which is used with some AM radio transmissions. Normally each sideband carries identical information, but ISB modulates two different input signals — one on the upper sideband, the other on the lower sideband. This is used in some kinds of AM stereo (sometimes known as the Kahn system).
The general convention is to filter the lower-sideband, and communicate using only the upper-sideband and a partial carrier. [1] The benefits of compatible-sideband over conventional AM are increased spectral efficiency due to a reduction in bandwidth of 50% as well as a decrease in wasted power. By using compatible sideband instead of AM, less ...
sideband cooling loops are applied at the first red sideband of the D 5/2 (m=-5/2) 729 nm transition; to ensure the population ends up in the S 1/2 (m=-1/2) state, another 397 nm pulse is applied; manipulation is carried out and analysis is carried out by applying 729 nm light at the frequency of interest