Ads
related to: 1 female 2 male splitter connector plug kit with 4 prongamazon.com has been visited by 1M+ users in the past month
pasternack.com has been visited by 10K+ users in the past month
sweetwater.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
A banana connector (commonly banana plug for the male, banana jack (or socket) for the female) is a single-wire (one conductor) electrical connector used for joining wires to equipment. The term 4 mm connector is also used, especially in Europe, although not all banana connectors will mate with 4 mm parts, and 2 mm banana connectors exist ...
A3F = Audio 3-pin female connector; A3M = Audio 3-pin male connector. The terms plug, pin, and prong are also often used for "male" connectors, and receptacle, socket, and slot are used for "female" connectors. In many cases these terms are more common than male and female, especially in documentation intended for the non-specialist. These ...
2.1 mm center pin Common on guitar effect pedals Arduino power adapter IEC 60130-10 Type A (first of two with same type and same OD, the other has ID of 2.5mm and center PIN) 5.50 2.10 CUI Inc. P10 Kobiconn 7391 Philmore 2560 Switchcraft 768K [8] 2.1 mm center pin, lock-ring: 5.50 2.10 Kobiconn 0721-EX Kobiconn 1000-EX (panel) 2.1 mm center pin ...
The 'combiner' and 'splitter' Y-leads are the same: two two-pole connectors on one end, connected to the ±1 and ±2 pins, respectively, of a four-pole line connector at the other end. [8] Some amplifiers and mixer-amplifiers are configured to do this without the need for a 'combiner'.
The connector typically has 2 to 24 contacts and is polarized or keyed to ensure correct orientation. Pins and sockets can be arranged in any combination in a single housing, and each housing can be either male or female. There are three typical pin sizes: 1.57 mm (0.062 in), 2.13 mm (0.084 in), and 2.36 mm (0.093 in).
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.