When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Registered jack - Wikipedia

   en.wikipedia.org/wiki/Registered_jack

   Cords connecting to an RJ11 interface require a 6P2C connector. Nevertheless, cords sold as RJ11 often use 6P4C connectors (six position, four conductor) with four wires. Two of the six possible contact positions connect tip and ring, and the other two conductors are unused. RJ11 is commonly used to connect DSL modems to the customer line.

3. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   An 8P8C modular plug. This is the common crimp-type plug, of the same kind pictured above crimped onto a cable (with molded sleeve). A modular connector is a type of electrical connector for cords and cables of electronic devices and appliances, such as in computer networking, telecommunication equipment, and audio headsets.

4. Telephone jack and plug - Wikipedia

   en.wikipedia.org/wiki/Telephone_jack_and_plug

   For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...

5. Medium-dependent interface - Wikipedia

   en.wikipedia.org/wiki/Medium-dependent_interface

   For 10BASE5, connection to the coaxial cable was made with either a vampire tap or a pair of N connectors. For 10BASE2, the connection to the coaxial cable was typically made with a single BNC connector to which a T-piece was attached. For twisted-pair cabling 8P8C, modular connectors are used (often called RJ45 in this context).

6. Ethernet crossover cable - Wikipedia

   en.wikipedia.org/wiki/Ethernet_crossover_cable

   A crossover cable may also be used to connect two hubs or two switches on their upstream ports. Because the only difference between the T568A and T568B pin and pair assignments are that pairs 2 and 3 are swapped, a crossover cable may be envisioned as a cable with one modular connector following T568A and the other T568B (see TIA/EIA-568 wiring ...

7. Keystone module - Wikipedia

   en.wikipedia.org/wiki/Keystone_module

   Some keystones use a pass-through type connector, where there is a jack on both the front face and the rear side. Others only have a jack on the front and employ a different mechanism for hard-wiring signal cables to the rear, such as a mini 110 block , an insulation-displacement connector , or a crimp or solder connection.