Search results
Results From The WOW.Com Content Network
The M3 is an American .45-caliber submachine gun adopted by the U.S. Army on 12 December 1942, as the United States Submachine Gun, Cal. .45, M3. [12] The M3 was chambered for the same .45 ACP round fired by the Thompson submachine gun , but was cheaper to mass produce and lighter, at the expense of accuracy. [ 12 ]
By 1935, Milwaukee Electric Tool Corporation developed a lightweight 3/4" electric hammer drill. This power tool was designed to drill and sink anchors into concrete. This drill could also be converted into a standard 3/4" drill. Milwaukee also designed an easy-to-handle, single-horsepower sander/grinder that weighed only 15 pounds. [7]
A grease gun (pneumatic) A grease gun is a common workshop and garage tool used for lubrication. The purpose of the grease gun is to apply lubricant through an aperture to a specific point, usually from a grease cartridge to a grease fitting or 'nipple'. The channels behind the grease nipple lead to where the lubrication is needed.
Grease fitting on a bearing A grease nipple on the driver's door of a 1956 VW Beetle. A grease fitting, grease nipple, Zerk fitting, grease zerk, Alemite fitting, or divit is a metal fitting used in mechanical systems to feed lubricants, usually lubricating grease, into a bearing under moderate to high pressure using a grease gun.
Lincoln patented the first lever grease gun to work with a full stroke operation called the Model 1242. This meant that a hand-held grease gun could generate up to 10,000 lbf/in² (70 MPa) of pressure. Operators of the unit could push grease into blocked or "frozen" fittings and the unit allowed for work in confined areas.
The most common causes are accidents with grease guns, paint sprayers, and pressure washers, but working on diesel and gasoline engine fuel injection systems as well as pinhole leaks in pressurized hydraulic lines can also cause this injury. Additionally, there is at least one known case of deliberate self-injection with a grease gun. [2]
Wadham's Oil and Grease Company of Milwaukee was a chain of filling and service stations that operated in the early 20th century and was headquartered in Milwaukee, Wisconsin. The company's refinery was in Indiana. The company was headed by Harger W. Dodge, who assumed leadership from his father-in-law in 1916.
Waste from passive grease traps and gravity interceptors is called brown grease. Brown grease is rotted food solids in combination with fats, oils, and grease (FOG). Brown grease is pumped from the traps and interceptors by grease pumping trucks. Unlike the collected yellow grease, the majority of brown grease goes to landfill sites. New ...