Ads
related to: trailer connector pinout diagram
Search results
Results From The WOW.Com Content Network
13-pin trailer connector of Jaeger type. (screw terminals - trailer PLUG). see photograph typical rear of 13 pin trailer Plug showing terminals with pin numbers. Physical design of the standard ISO 11446 [2] [3] but also called Jaeger-connector from the company that developed it.
If you have a trailer with a lot of lights the diode and relay wiring is preferred, but if you have a trailer with a simple light arrangement it is usually sufficient to wire to 58L. In market there are many special converters [ 1 ] [ 2 ] [ 3 ] that solves the problem of connecting a car with European wiring to a trailer with North American wiring.
A trailer connector is a multi-pole electrical connector between a towing vehicle (car, truck) and a trailer. It is intended primarily to supply automotive lighting on the trailer, but also provide management and supply to other loads. It is also referred to as "trailer wire," "trailer cable," or "trailer connecting cable."
Trailer connector according to NATO STANAG 4007. NATO uses a 12-pin connector [NATO 1] [NATO 2] according to STANAG 4007. [1] However, note that there are often deviations from the standard depending on which country it is applied, which means that the table below may not be accurate.
Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...
ISO 11446:2004 specifies a 13-pole electrical connector between towing and towed vehicles with 12 volt electrical system. It was developed in 1987 by Erich Jaeger [ 1 ] to replace older 7-pin plugs. Notes
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Round 7-pin trailer connector Type 1, Australian Standard 2513. In this pinout for an ISO 1724 connector, the position light pin is used for electric brakes (Pin 5, 58R), which means that if you connect a trailer with electric brakes to a towing vehicle wired according to ISO 1724 and turn on the position lights the trailer will be braking. Pin ...