Search results
Results From The WOW.Com Content Network
The inclusion of depletion-mode NMOS transistors in the manufacturing process demanded additional manufacturing steps compared to the simpler enhancement-load circuits; this is because depletion-load devices are formed by increasing the amount of dopant in the load transistors channel region, in order to adjust their threshold voltage.
Such devices are used as load "resistors" in logic circuits (in depletion-load NMOS logic, for example). For N-type depletion-load devices, the threshold voltage might be about −3 V, so it could be turned off by pulling the gate 3 V negative (the drain, by comparison, is more positive than the source in NMOS).
The major drawback with NMOS (and most other logic families) is that a direct current must flow through a logic gate even when the output is in a steady state (low in the case of NMOS). This means static power dissipation , i.e. power drain even when the circuit is not switching, leading to high power consumption.
A logic family of monolithic digital integrated circuit devices is a group of electronic logic gates constructed using one of several different designs, usually with compatible logic levels and power supply characteristics within a family. Many logic families were produced as individual components, each containing one or a few related basic ...
The depletion region has to be closed to enable current to flow. JFETs can have an n-type or p-type channel. In the n-type, if the voltage applied to the gate is negative with respect to the source, the current will be reduced (similarly in the p-type, if the voltage applied to the gate is positive with respect to the source).
From Wikipedia, the free encyclopedia. Redirect page
This process was aided by the recent introduction of depletion mode NMOS logic, which greatly simplified the conceptual model of the active elements. [6] The mid-1970s were a period of rapid change as new processes were being introduced at different companies at a rapid pace. Each new process led to a set of design rules that often ran to 40 pages.
It is also used in low-voltage interface circuits. In most CMOS processes, native N-channel MOSFETs are fabricated on the "native" slightly p-doped silicon that comprises the bulk region, whereas a non-native N-channel MOSFET is fabricated in a p-well, which has a higher concentration of positive charges due to the increased presence of holes. [1]