Search results
Results From The WOW.Com Content Network
The Dynamic Host Configuration Protocol (DHCP) is a network management protocol used on Internet Protocol (IP) networks for automatically assigning IP addresses and other communication parameters to devices connected to the network using a client–server architecture.
Packet Tracer is a cross-platform visual simulation tool designed by Cisco Systems that allows users to create network topologies and imitate modern computer networks.The software allows users to simulate the configuration of Cisco routers and switches using a simulated command line interface.
If a DHCP client outside the DHCP server's subnet broadcasts an address request, it is the helper that forwards the message to the DHCP server. The server then chooses an address and sends the client a unicast message, using the helper to send the message back to the client's subnet. The address is reserved for a limited time while the DHCP ...
Zero-configuration networking (zeroconf) is a set of technologies that automatically creates a usable computer network based on the Internet Protocol Suite (TCP/IP) when computers or network peripherals are interconnected. It does not require manual operator intervention or special configuration servers.
The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network.
dhcpd (an abbreviation for "DHCP daemon") was a DHCP server program that operates as a daemon on a server to provide Dynamic Host Configuration Protocol (DHCP) service to a network. [3] This implementation, also known as ISC DHCP, is one of the first and best known, but there are now a number of other DHCP server software implementations available.
Network Admission Control (NAC) refers to Cisco's version of network access control, which restricts access to the network based on identity or security posture.When a network device (switch, router, wireless access point, DHCP server, etc.) is configured for NAC, it can force user or machine authentication prior to granting access to the network.
In a correct architecture and configuration, the Clean Access Server would hand out IP subnets and addresses via DHCP on its untrusted interface using a 30-bit network address and 2 bits for hosts, therefore only one host could be placed in each DHCP scope/subnet at any given time. This segregates unauthorized users from each other and from the ...