Ad
related to: how to read a mitutoyo micrometer chart video
Search results
Results From The WOW.Com Content Network
Modern micrometer with a reading of 1.639 ± 0.005 mm. Assuming no zero error, this is also the measurement. (One may need to enlarge the image to read it.) Outside, inside, and depth micrometers. The outside micrometer has a unit conversion chart between fractional and decimal inch measurements etched onto the frame
The main scale reading is that to the left of the zero on the vernier scale. The vernier reading is found by locating the best aligned lines between the two scales. The 0.02 mm engraving indicates the caliper's readability and is the "vernier constant" for this scale.
Mitutoyo America Corporation was formed in 1963 and is headquartered in Aurora, Illinois (just outside Chicago).Mitutoyo America offers the full product line of precision measuring tools, instruments and equipment with a distribution network, training and education classes, software development, and service support to provide a comprehensive metrology organization.
Micrometers are often, but not always, in the form of calipers. Profile gauge or contour gauge a tool for recording the cross-sectional shape of a surface. Radius gauge, also known as a fillet gauge a tool used to measure the radius of an object. Radius gauges require a bright light behind the object to be measured.
In this instrument, a small, precise rack and pinion drives a pointer on a circular dial, allowing direct reading without the need to read a vernier scale. Typically, the pointer rotates once every inch, tenth of an inch, or 1 millimeter. This measurement must be added to the coarse whole inches or centimeters read from the slide.
Surface metrology is the measurement of small-scale features on surfaces, and is a branch of metrology.Surface primary form, surface fractality, and surface finish (including surface roughness) are the parameters most commonly associated with the field.
Typical incremental scale periods vary from hundreds of micrometers down to sub-micrometer. Interpolation can provide resolutions as fine as a nanometer. Optical linear encoder mounted on Mitutoyo CMM. Light sources used include infrared LEDs, visible LEDs, miniature light-bulbs and laser diodes.
When using the chart, it is important to remember these tips: Isotropic and opaque (metallic) minerals cannot be identified this way. The stage of the microscope should be rotated until maximum colour is found, and therefore, the maximum birefringence. Each mineral, depending on the orientation, may not exhibit the maximum birefringence.