Search results
Results From The WOW.Com Content Network
The output for the front drive shaft is on the right side and the rear output is in line with the input. This enables 2-wheel High to be direct-drive, which is quieter. Otherwise the Dana 20 offers the same drive modes as the Dana 18. Its low range has a ratio of 2.03:1. The Dana 20 is generally compatible with the "big hole" Dana 18.
When in "4-Low" mode the front and rear axles are locked together and power is sent to all four-wheels through the power transfer unit although no low range gear reduction occurs. Active Drive low relies on shorter axle gear ratios while holding first gear in the ZF9HP transmission to achieve a crawl ratio of 20:1; similar in effect to Freedom ...
Typical gear ratios on bicycles range from very low or light gearing around 20 gear inches (1.6 metres per revolution), via medium gearing around 70 gear inches (5.6 m), to very high or heavy gearing around 125 gear inches (10 m). As in a car, low gearing is for going up hills and high gearing is for going fast.
The Dana S110 is a full floating, drop-out axle. Dana S110 axles are a step up in overall strength compared to the Dana 80. Ford started using this axle in 2005 model F-450 and F-550 trucks. Replacing the Dana 80 in some class 4 trucks, and the Dana S 135 in the rest of the trucks. Dodge started using the Dana S110 in their 2008 model 4500 and ...
Converter w/ Lockup Hydraulic 4HP 24: 400 N⋅m (295 lb⋅ft) 1987 – 2004 Longitudinal: 2.4795 0.7281 4 3.4055 1.5045 1.3436 S 3 4 3 Torque Converter w/ Lockup Hydraulic 4HP 20: TBD 1995 – Transverse: TBD 4 TBD TBD S 3 2 3 Torque Converter: Hydraulic 4HP 16: TBD 2004 – 2008 Transverse: TBD 4 TBD TBD S 3 2 3 Torque Converter: Hydraulic 5HP 18
The designation of wide versus close ratio affected the lowest gear ratio; [7] for example, the four-speed Muncie transmissions offered in General Motors performance vehicles included the M20 "wide ratio" transmission, which had a first gear ratio of 2.52 or 2.56:1, while the M21 and M22 "close ratio" transmissions had a first gear ratio of 2. ...
Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks. The Dana 44 was manufactured in kingpin and ball joint variations, as well as closed and open knuckle variations.
A transmission (also called a gearbox) is a mechanical device which uses a gear set—two or more gears working together—to change the speed, direction of rotation, or torque multiplication/reduction in a machine. [1] [2] Transmissions can have a single fixed-gear ratio, multiple distinct gear ratios, or continuously variable ratios. Variable ...