Search results
Results From The WOW.Com Content Network
The output for the front drive shaft is on the right side and the rear output is in line with the input. This enables 2-wheel High to be direct-drive, which is quieter. Otherwise the Dana 20 offers the same drive modes as the Dana 18. Its low range has a ratio of 2.03:1. The Dana 20 is generally compatible with the "big hole" Dana 18.
When in "4-Low" mode the front and rear axles are locked together and power is sent to all four-wheels through the power transfer unit although no low range gear reduction occurs. Active Drive low relies on shorter axle gear ratios while holding first gear in the ZF9HP transmission to achieve a crawl ratio of 20:1; similar in effect to Freedom ...
Typical gear ratios on bicycles range from very low or light gearing around 20 gear inches (1.6 metres per revolution), via medium gearing around 70 gear inches (5.6 m), to very high or heavy gearing around 125 gear inches (10 m). As in a car, low gearing is for going up hills and high gearing is for going fast.
The line was offered in four ratings, M-300, M-375 (also known as M-400 between 1969–1973), [1] M-500, and M-600 depending on the application. The M600 was offered with the Rockwell F-130-NX rear axle, with a 4.88:1 gear ratio. By 1979, Chrysler Corporation no longer sold incomplete chassis and ended production of the M series.
The Dana S110 is a full floating, drop-out axle. Dana S110 axles are a step up in overall strength compared to the Dana 80. Ford started using this axle in 2005 model F-450 and F-550 trucks. Replacing the Dana 80 in some class 4 trucks, and the Dana S 135 in the rest of the trucks. Dodge started using the Dana S110 in their 2008 model 4500 and ...
The gear range is difference between the highest and lowest gear ratios and may be expressed as a percentage (e.g., 500%) or as a ratio (e.g., 5:1). Heel [ edit ]
The Dana 50 has a "50" cast into the housing and is regarded to have more strength than a Dana 44, but not as much as a Dana 60. It was only produced in a reverse cut gear set aka a high pinion. The Dana 50 was made as a solid axle and as a Twin Traction Beam (TTB) which pivots in the center allowing the wheels to move independently of each ...
Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks. The Dana 44 was manufactured in kingpin and ball joint variations, as well as closed and open knuckle variations.