Search results
Results From The WOW.Com Content Network
1.75 m – (5 feet 8 inches) – height of average U.S. male human as of 2002 (source: U.S. CDC as per female above) 2.4 m – wingspan of a mute swan; 2.5 m – height of a sunflower; 2.7 m – length of a leatherback sea turtle, the largest living turtle; 2.72 m – (8 feet 11 inches) – tallest-known human (Robert Wadlow) [31]
At the time, Smoot was 5 feet, 7 inches, or 170 cm, tall. [18] Google Earth and Google Calculator include the smoot as a unit of measurement. The Cambridge (Massachusetts) police department adopted the convention of using Smoots to measure the locations of accidents and incidents on the bridge.
long code "foot" outputs foot (and never feet) Use of ′ and ″ symbols violates MOSNUM so is not provided. 1.0 ft (0.30 m) ftin (feet and inches) ft m (foot m) inch: in in Use of ′ and ″ symbols violates MOSNUM so is not provided. 1.0 in (25 mm) in cm; in mm; Other: nautical mile: nmi nmi the international standard nautical mile
A foot-lambert or footlambert (fL, sometimes fl or ft-L) is a unit of luminance in United States customary units and some other unit systems. A foot-lambert equals 1/π or 0.3183 candela per square foot , or 3.426 candela per square meter (the corresponding SI unit ).
The customary system is offset by 1 ⁄ 4 barleycorn, or 1 ⁄ 12 in (2.12 mm), comparing to the UK sizes. The men's range starts at size 1, with zero point corresponding to the children's size 13 which equals 24 + 3 ⁄ 4 barleycorns or 8 + 1 ⁄ 4 inches (20.96 cm). However, most US manufacturers are using greater offsets, such as 1 ⁄ 2 and ...
A thousandth of an inch is a derived unit of length in a system of units using inches. Equal to 1 ⁄ 1000 of an inch, a thousandth is commonly called a thou / ˈ θ aʊ / (used for both singular and plural) or, particularly in North America, a mil (plural mils). The words are shortened forms of the English and Latin words for "thousand" (mille ...
8-, 5.25-, 3.5-, 2.5-, 1.8- and 1-inch HDDs, together with a ruler to show the length of platters and read-write heads A newer 2.5-inch (63.5 mm) 6,495 MB HDD compared to an older 5.25-inch full-height 110 MB HDD. IBM's first hard drive, the IBM 350, used a stack of fifty 24-inch platters and was of a size comparable to two large refrigerators.
Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.