Ads
related to: 1 8 socket 4 drive set with 2 pin plug
Search results
Results From The WOW.Com Content Network
The de facto standard for 3.5 inch drives uses a 34-pin header mating to an IDC Berg connector, collectively slightly smaller than the PCB edge pin connector and mating socket used for the 5¼ inch standard but with the same 34 pin definitions as the 5¼ inch standard. [7] A separate connector is provided for DC power. [1]
The male PCB connector on the 3½-inch floppy drive is normally a polarized right-angle male header, which is a TE Connectivity / AMP 171826-4, [4] the straight model is AMP 171825-4. [ 5 ] The shape of the connector housing makes it very easy to determine the pin number allocations by visual inspection.
For Wide SCSI-2, the most common connector was the larger 68-pin sibling of the HD50, known as the HD68, MiniD68, HPDB68, and sometimes as "SCSI-3". This is about 1 7/8” (47mm) wide. [3] IBM used the HDCN68 on some RS-6000 systems, and it seems likely that a few other manufacturers used other alternatives.
Pass-through sockets and ratchets are built for 1 ⁄ 4-inch, 3 ⁄ 8-inch and 1 ⁄ 2-inch sets in both SAE and metric sizes. By using a fine tooth ratchet and socket system that allow a pass-through ratchet to be used as a conventional ratchet handle with interchangeable 1 ⁄ 4-inch and 3 ⁄ 8-inch drives some ratchets can be used with ...
CTL-I (Controller Interface) [3] was an 8-bit word serial interface introduced by IBM for its mainframe hard disk drives beginning with the 3333 in 1972. [4] The 3333 was the first unit in a string of up to eight 3330 type hard disk drives ; it contained a CTL-I controller and two 3330 type disk drives.
Pins and sockets can be arranged in any combination in a single housing, and each housing can be either male or female. There are three typical pin sizes: 1.57 mm (0.062 in), 2.13 mm (0.084 in), and 2.36 mm (0.093 in). The 1.57 mm pin can carry 5 A of current, while the 2.36 mm can carry 8.5 A.