Ad
related to: wire lath for corners
Search results
Results From The WOW.Com Content Network
Wire lath is made from welded or woven wires and is similar to hardware cloth; Paper backed wire lath is wire lath with building paper attached; Strip laths is metal lath that is several inches wide and is often used to reinforce joints and on corners; Corner lath is pre-bent for use in making corners; Wire mesh used on inside corners to ...
Each wall frame is covered in lath, tacked at the studs. Wood lath is typically about one inch (2.5 cm) wide by four feet (1.2 m) long by 1 ⁄ 4 inch (6 mm) thick. Each horizontal course of lath is spaced about 3 ⁄ 8 inch (9.5 mm) away from its neighboring courses. Metal lath is available in 27-inch (69 cm) by 8-foot (240 cm) sheets.
A wide variety of stucco accessories, such as weep screeds, control and expansion joints, corner-aids and architectural reveals are sometimes also incorporated into the lath. Wire lath is used to give the plaster something to attach to and to add strength. Types include expanded-metal lath, woven-wire lath, and welded-wire lath.
It is made of thin, flexible, galvanized steel wire with hexagonal gaps. Available in 1 ⁄ 2 inch (about 1.3 cm), 1 inch (about 2.5 cm) diameter, and 2 inch (about 5 cm), chicken wire is available in various gauges—usually 19 gauge (about 1 mm wire) to 22 gauge (about 0.7 mm
An interior or exterior corner, with an angle or type of bevel, is called a "chamfer". Fillet geometry, when on an interior corner is a line of concave function , whereas a fillet on an exterior corner is a line of convex function (in these cases, fillets are typically referred to as rounds).
Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...
The finished product leaves only a small exposed metal strip at the protrusion of the corner which gets covered when the wall is painted. This leaves a clean, straight looking corner. An alternative method seen in older houses of forming a rounded or bullnosed corner uses a quirked wooden staff bead.
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.