Ads
related to: heavy duty sail shade poles detailing equipment kits
Search results
Results From The WOW.Com Content Network
Shade sail over playground in Australia. A shade sail − or somewhat more precise a textile sunshade sail or a textile sun protection sail − is a device to create outdoor shade based on the textile basic technology that can be found in a ship's sail. [1] Shade sails use a flexible membrane tensioned between several anchor points. While ...
The spinnaker pole is rigged to run from the base of the mast, [1] where there is a special fitting for attaching one end of the pole, out to windward over the side of the boat. There, one of the control lines of whichever sail it is to be used with is run through a fitting on the other end of the spinnaker pole. This allows for more precise ...
Two primary sail control lines are attached to every boom: The outhaul runs from the clew of the sail to the free end of the boom. Hauling in on (tightening) the outhaul increases foot tension in the main sail. Modern loose footed sails are cut so that the outhaul is also able to pull the clew downwards towards the boom.
However, under sail on a given tack, the corner to which the spinnaker sheet is attached is called the clew, and the corner attached to the spinnaker pole is referred to as the tack. [20] Tack – The tack is the corner on a fore-and-aft sail where the luff and foot connect [8] and, on a mainsail, is located where the boom and mast connect.
Mizzen: the aftmost mast and sail in a yawl or ketch, or in a vessel with three or more masts. Oar a wooden pole enlarged on one end to resist the water when pulled. Painter: a short line at the bow of a small boat for tying it off. Parrot beak: a spring-loaded stainless steel fitting on the end of a spinnaker pole attaching it to the sail.
14 – spinnaker pole 15 – backstay 16 – forestay 17 – boom vang Stays are ropes, wires, or rods on sailing vessels that run fore-and-aft along the centerline from the masts to the hull, deck, bowsprit, or to other masts which serve to stabilize the masts. [1] A stay is part of the standing rigging and is used to hold a mast upright.