Search results
Results From The WOW.Com Content Network
Cordite was used initially in the .303 British, Mark I and II, standard rifle cartridge between 1891 and 1915. [not verified in body] Shortages of cordite in World War I led to the creation of the "Devil's Porridge" munitions factory (HM Factory, Gretna) on the English–Scottish border, which produced around 800 tonnes of cordite per week. The ...
Firstly, cordite was not readily available except sealed in ammunition which was controlled issue. To remove the bullet from a .303 cartridge requires a minimum of 60 pounds pull with very little to grip on. Cordite is a very hard materiel and not easily chewed.(I have tried) and is almost totally insoluble in water (and hence body fluids).
A 3 + 1 ⁄ 8-inch variant would later be loaded with cordite to become the .577/500 Nitro Express. [1] For some time the .577/500 No. 2 BPE was loaded with cordite to become the .577/500 No. 2 Nitro for Black, the same cartridge loaded with mild loadings of cordite, carefully balanced through trial to replicate the ballistics of the black ...
The .450/400 Nitro Express is a Nitro Express rifle cartridge that is produced in three case lengths: 2 3 ⁄ 8-inches, 3 inches and 3 1 ⁄ 4-inches, [2] and is intended for use in single shot and double rifles. The 3-inch and 3 1 ⁄ 4-inch versions are considered classic Nitro Express cartridges.
The .577/450 Martini–Henry is a rimmed, bottlenecked centerfire rifle cartridge derived from the .577 Snider, it was lengthened and bottlenecked. The .577/450 Martini–Henry was developed for use in the single shot Martini–Henry service rifle, originally loaded with blackpowder but later used cordite propellant.
Handgun propellants may reach peak pressure before the bullet leaves the cartridge case, while rifle propellants may move a bullet several inches before reaching peak pressure. [4]: 125 The motion and behavior characteristics of projectiles while under the influence of the gases produced by the propellant is known as internal ballistics. [13]
The United States Army evaluated 25 varieties of smokeless powder and selected Ruby and Peyton Powders as the most suitable for use in the Krag–Jørgensen service rifle. Ruby was preferred, because tin-plating was required to protect brass cartridge cases from picric acid in the Peyton Powder.
The .500/450 Magnum BPE was created by necking down the .500 Black Powder Express to .45-inches. [2]For some time after the turn of the century, the .500/450 Magnum BPE was loaded with cordite to become the .500/450 Magnum Nitro for Black, the same cartridge loaded with mild loadings of cordite, carefully balanced through trial to replicate the ballistics of the Black powder version.