Search results
Results From The WOW.Com Content Network
When reading from memory, data addressed by MAR is fed into the MDR (memory data register) and then used by the CPU. When writing to memory, the CPU writes data from MDR to the memory location whose address is stored in MAR. MAR, which is found inside the CPU, goes either to the RAM (random-access memory) or cache.
In a computer using virtual memory, accessing the location corresponding to a memory address may involve many levels. In computing, a memory address is a reference to a specific memory location in memory used by both software and hardware. [1] These addresses are fixed-length sequences of digits, typically displayed and handled as unsigned ...
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.
Direct memory access (DMA) is a feature of computer systems that allows certain hardware subsystems to access main system memory independently of the central processing unit (CPU). [ 1 ] Without DMA, when the CPU is using programmed input/output , it is typically fully occupied for the entire duration of the read or write operation, and is thus ...
If the address field is non-zero, it is a disk address of the block, which has previously been rolled out — the block is fetched from disk, the pbit is set to one and the physical memory address updated to point to the block in memory. This makes descriptors equivalent to a page-table entry in an MMU system, but descriptors are free of a table.
The instruction's location (address) in program memory is determined by the program counter (PC; called the "instruction pointer" in Intel x86 microprocessors), which stores a number that identifies the address of the next instruction to be fetched. After an instruction is fetched, the PC is incremented by the length of the instruction so that ...
An address bus is a bus that is used to specify a physical address. When a processor or DMA-enabled device needs to read or write to a memory location, it specifies that memory location on the address bus (the value to be read or written is sent on the data bus). The width of the address bus determines the amount of memory a system can address.
# This gives the memory system two clock ticks to fetch the next # instruction to the memory data register for use by the instruction decode. # The sequencer instruction "next" means just add 1 to the control word address. MDR, NONE, MAR, COPY, NEXT, NONE # This places the address of the next instruction into the PC. # This gives the memory ...