Ad
related to: bolt with hole for padlock and key ring kit reviews problems video youtube
Search results
Results From The WOW.Com Content Network
The clevis is a U-shaped piece that has holes at the end of the prongs to accept the clevis pin. The clevis pin is similar to a bolt, but is either partially threaded or unthreaded with a cross-hole for a split pin. A tang is a piece that is sometimes fitted in the space within the clevis and is held in place by the clevis pin.
A deadlocking latch bolt (deadlatch) is an elaboration on the latch bolt which includes a guardbolt to prevent "shimming" or "jimmying" of the latch bolt. When the door is closed, the latch bolt and guardbolt are retracted together, and the door closes normally, with the latch bolt entering the strike plate.
Padlocks with modular locking mechanisms can often be taken apart to change the tumblers or to service the lock. Modular locking mechanism cylinders frequently employ pin, wafer, and disc tumblers. Padlocks with modular mechanisms are usually automatic, or self-locking (that is, the key is not required to lock the padlock)
In pin tumbler locks, the series of key cuts on a key causes the pins to line up at the shear line or gate so the lock will open. In warded locks, the key cuts bypass the wards so the key can push or pull the bolt. [6] Key pin In a pin tumbler lock, the key pin is in contact with the key. It has varying lengths, corresponding to the key's ...
This example has two bolts: a sprung latch at the top, and a locking bolt at the bottom. Right: the box keep, installed in the doorjamb. A mortise lock (also spelled mortice lock in British English) is a lock that requires a pocket—the mortise—to be cut into the edge of the door or piece of furniture into which the
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
For example, if a standard automotive bolt in the U.S. is being secured, then the safety wire when installed should put tension on the bolt in a clockwise direction, since that is the direction that the bolt turns to tighten. [7] When drilling a fastener, the choice of where to drill it depends on the type of fastener and to what it will be wired.
Upgrade to a faster, more secure version of a supported browser. It's free and it only takes a few moments: