Search results
Results From The WOW.Com Content Network
For example, if two inductors are in series, there are two possible equivalent inductances depending on how the magnetic fields of both inductors influence each other. When there are more than two inductors, the mutual inductance between each of them and the way the coils influence each other complicates the calculation.
Series RL, parallel C circuit with resistance in series with the inductor is the standard model for a self-resonant inductor. A series resistor with the inductor in a parallel LC circuit as shown in Figure 4 is a topology commonly encountered where there is a need to take into account the resistance of the coil winding and its self-capacitance.
A resistor–inductor circuit (RL circuit), or RL filter or RL network, is an electric circuit composed of resistors and inductors driven by a voltage or current source. [1] A first-order RL circuit is composed of one resistor and one inductor, either in series driven by a voltage source or in parallel driven by a current source.
Mutually coupled inductors can equivalently be represented by a T-circuit of inductors as shown. If the coupling is strong and the inductors are of unequal values then the series inductor on the step-down side may take on a negative value. [32] This can be analyzed as a two port network.
Capacitors and inductors as used in electric circuits are not ideal components with only capacitance or inductance.However, they can be treated, to a very good degree of approximation, as being ideal capacitors and inductors in series with a resistance; this resistance is defined as the equivalent series resistance (ESR) [1].
[2] An easy way to deal with these inherent inductances in circuit analysis is by using a lumped element model to express each physical component as a combination of an ideal component and a small inductor in series, the inductor having a value equal to the inductance present in the non-ideal, physical device.
Figure 1: Essential meshes of the planar circuit labeled 1, 2, and 3. R 1, R 2, R 3, 1/sC, and sL represent the impedance of the resistors, capacitor, and inductor values in the s-domain. V s and I s are the values of the voltage source and current source, respectively. Mesh analysis (or the mesh current method) is a circuit analysis method for ...
Fig. 1 shows the common-base Colpitts circuit. The inductor L and the series combination of C 1 and C 2 form the resonant tank circuit, which determines the frequency of the oscillator. The voltage across C 2 is applied to the base-emitter junction of the transistor, as feedback to create oscillations. Fig. 2 shows the common-collector version.