Ads
related to: pneumatic tire rolling resistance ratings chart explained today fulldiscounttire.com has been visited by 100K+ users in the past month
tirerack.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
Low rolling resistance tires are designed to reduce the energy loss as a tire rolls, decreasing the required rolling effort — and in the case of automotive applications, improving vehicle fuel efficiency as approximately 5–15% of the fuel consumed by a typical gas car may be used to overcome rolling resistance.
Rolling resistance, sometimes called rolling friction or rolling drag, is the force resisting the motion when a body (such as a ball, tire, or wheel) rolls on a surface. It is mainly caused by non-elastic effects; that is, not all the energy needed for deformation (or movement) of the wheel, roadbed, etc., is recovered when the pressure is removed.
Starting in 1972 tires were specified by load rating, using a letter code. In practice, a higher load rating tire was also a wider tire. In this system a tire had a letter, optionally followed by "R" for radial tires, followed by the aspect ratio, a dash and the diameter – C78-15 or CR78-15 for bias and radial, respectively. Each diameter of ...
Rolling resistance is the main key factor in measuring the energy efficiency of a tyre and has direct influence on the fuel consumption of a vehicle. A set of tyres of the green class "A" compared to a "G" class can reduce fuel consumption by 9% [3] of a passenger car; even more for trucks.
In a non-scientific study (I looked at tires available from a national chain that fit my car), 85 percent of LRR tires had an “A” rating for traction, compared to 87 percent of Non-LRR tires.
Pneumatic tires also have a much lower rolling resistance than solid tires. Because the internal air pressure acts in all directions, a pneumatic tire is able to "absorb" bumps in the road as it rolls over them without experiencing a reaction force opposite to the direction of travel, as is the case with a solid (or foam-filled) tire. [26]
Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...
In a pneumatic tire, pressurized air is held inside either with a separate, relatively impermeable inner tube, or by the tire and rim, in a tubeless system. Pneumatic tires are superior in providing effective cushioning while keeping rolling resistance very low.