Search results
Results From The WOW.Com Content Network
Ansys HFSS (high-frequency structure simulator) is a commercial finite element method solver for electromagnetic (EM) structures from Ansys. [ 1 ] Engineers use Ansys HFSS primarily to design and simulate high-speed, high-frequency electronics in radar systems, communication systems, satellites, ADAS, microchips, printed circuit boards, IoT ...
6- and 10-pin ISP header diagrams. The in-system programming (ISP) programming method is functionally performed through SPI, plus some twiddling of the Reset line. As long as the SPI pins of the AVR are not connected to anything disruptive, the AVR chip can stay soldered on a PCB while reprogramming. All that is needed is a 6-pin connector and ...
With a switched-mode PSU the switching frequency can be chosen to keep the noise out of the circuits working frequency band (e.g., for audio systems above the range of human hearing) Electronic noise at the input terminals: Causes harmonic distortion to the input AC, but relatively little or no high-frequency noise.
An Alexanderson alternator is a motor-driven, high-frequency alternator which provides radio frequency power. In the early days of radio communication, the high frequency carrier wave had to be produced mechanically using an alternator with many poles driven at high speeds. Alexanderson alternators produced RF up to 600 kHz, with large units ...
Transformers, autotransformers, and baluns are sometimes incorporated into the design of narrow band antenna tuners and antenna cabling connections. They will all usually have little effect on the resonant frequency of either the antenna or the narrow band transmitter circuits, but can widen the range of impedances that the antenna tuner can match, and/or convert between balanced and ...
These transmitters operate in the high frequency (HF) range (3-30 MHz) at which radio waves are reflected from the ionosphere back to the ground. With such facilities a range of plasma turbulence phenomena can be excited in a semi-controlled fashion from the ground, during conditions when the ionosphere is naturally quiet and not perturbed by ...
The audio DAC is a low-frequency, high-resolution type while the video DAC is a high-frequency low- to medium-resolution type. Due to the complexity and the need for precisely matched components , all but the most specialized DACs are implemented as integrated circuits (ICs).
1.1 All outputs (D 2) are set to a high level, all pull-downs are turned off 1.2 The first SNPD node is selected. It is identified by having the input D 1 low (hardwired). 1.3 The selected node takes the address from the LIN configuration message 1.4 The detected node turns on the pull-down at the output D 2. 2 Subsequent auto-addressing LIN ...