Ads
related to: differential pressure units
Search results
Results From The WOW.Com Content Network
The units are conventionally used for measurement of certain pressure differentials such as small pressure differences across an orifice, or in a pipeline or shaft, [1] or before and after a coil in an HVAC unit. It is defined as the pressure exerted by a column of water of 1 inch in height at defined conditions.
In the cgs system the unit of pressure was the barye (ba), equal to 1 dyn·cm −2. In the mts system, the unit of pressure was the pieze, equal to 1 sthene per square metre. Many other hybrid units are used such as mmHg/cm 2 or grams-force/cm 2 (sometimes as kg/cm 2 without properly identifying the force units). Using the names kilogram, gram ...
A DP cell is a device that measures the differential pressure between two inputs. [1]Example: To measure the pressure difference between a container (or vessel) and the surrounding atmosphere, you may connect 'Hi' port of the DP-cell to a fitting that enters the vessel, using suitable tubing.
For example, a bicycle tire pumped up to 65 psig in a local atmospheric pressure at sea level (14.7 psi) will have a pressure of 79.7 psia (14.7 psi + 65 psi). [2] [3] When gauge pressure is referenced to something other than ambient atmospheric pressure, then the unit is pound per square inch differential (psid).
The Dall tube is a shortened version of a Venturi meter, with a lower pressure drop than an orifice plate. As with these flowmeters the flow rate in a Dall tube is determined by measuring the pressure drop caused by restriction in the conduit. The pressure differential is typically measured using diaphragm pressure transducers with digital readout.
where (in SI units): q is the dynamic pressure in pascals (i.e., N/m 2, ρ (Greek letter rho) is the fluid mass density (e.g. in kg/m 3), and; u is the flow speed in m/s. It can be thought of as the fluid's kinetic energy per unit volume. For incompressible flow, the dynamic pressure of a fluid is the difference between its total pressure and ...
Other units of pressure, such as pounds per square inch (lbf/in 2) and bar, are also in common use. The CGS unit of pressure is the barye (Ba), equal to 1 dyn·cm −2, or 0.1 Pa. Pressure is sometimes expressed in grams-force or kilograms-force per square centimetre ("g/cm 2" or "kg/cm 2") and the like without properly identifying the force ...
In the picture on the right, the pressure differential is entirely due to the change in velocity head of the fluid, but it can be measured as a pressure head because of the Bernoulli principle. If, on the other hand, we could measure the velocity of the fluid, the pressure head could be calculated from the velocity head.