Search results
Results From The WOW.Com Content Network
The routing prefix of an address is identified by the subnet mask, written in the same form used for IP addresses. For example, the subnet mask for a routing prefix that is composed of the most-significant 24 bits of an IPv4 address is written as 255.255.255.0.
A subnet mask is a bitmask that encodes the prefix length associated with an IPv4 address or network in quad-dotted notation: 32 bits, starting with a number of 1-bits equal to the prefix length, ending with 0-bits, and encoded in four-part dotted-decimal format: 255.255.255.0. A subnet mask encodes the same information as a prefix length but ...
A wildcard mask is a mask of bits that indicates which parts of an IP address are available for examination. In the Cisco IOS, [1] they are used in several places, for example: To indicate the size of a network or subnet for some routing protocols, such as OSPF. To indicate what IP addresses should be permitted or denied in access control lists ...
The term subnet mask is only used within IPv4. Both IP versions however use the CIDR concept and notation. In this, the IP address is followed by a slash and the number (in decimal) of bits used for the network part, also called the routing prefix. For example, an IPv4 address and its subnet mask may be 192.0.2.1 and 255.255.255.0, respectively.
If there are multiple routes with the same subnet mask, the route with the lowest metric is used. If there are multiple default routes, the metric is also used to determine which to use. If there are multiple routes with the same subnet mask and metric, the system may use equal-cost multi-path routing as a forwarding strategy.
network identifier: The destination subnet and netmask; metric: The routing metric of the path through which the packet is to be sent. The route will go in the direction of the gateway with the lowest metric. next hop: The next hop, or gateway, is the address of the next station to which the packet is to be sent on the way to its final destination
2. Subnet mask (The /12 in the IP address in this case means only the left-most 12 bits are 1s, as shown here. This reserves the left 12 bits for the network address (prefix) and the right 32 - 12 = 20 bits for the host address (suffix).) 11111111.11110000.00000000.00000000: 255.240.0.0 3. Bit complement (bitwise NOT) of the subnet mask
Since it would not be practical to manually provision networks at scale, in IPv6 networking, DHCPv6 prefix delegation (RFC 3633; RFC 8415 § 6.3) is used to assign a network address prefix and automate configuration and provisioning of the public routable addresses for the network. In the typical case of a home network, for example, the home ...