Ads
related to: random antenna wiring diagram chart 134 diagram free
Search results
Results From The WOW.Com Content Network
Random wire antenna. A wire antenna kit, with a coil of wire, strain insulators and a balun. When installed the wire is supported by buildings or trees using the insulators to prevent a short circuit to ground. A random wire antenna is a radio antenna consisting of a long wire suspended above the ground, whose length does not bear a particular ...
The rhombic antenna is a directional wire antenna used on MF and HF bands for shortwave reception. The antenna consists of a wire suspended above the ground in the shape of a rhombus, terminated at one end by a resistor equal the the wire's characteristic impedance, about 400 to 600 ohms, and at the other end connected to the feedline to the ...
A rhombic antenna is made of four sections of wire suspended parallel to the ground in a diamond or "rhombus" shape. Each of the four sides is the same length – about a quarter-wavelength to one wavelength per section – converging but not touching at an angle of about 42° at the fed end and at the far end. The length is not critical ...
Assuming the building is about 20 feet tall, the length of wire seems to be on the order of 100 feet long – too short to be an HF Beverage antenna. Random wire antenna Moxon (1993) describes the random-wire antenna as an "odd bit of wire". [13] [page needed] It is the typical informal antenna erected for receiving shortwave and AM radio.
In the field of antenna design the term radiation pattern (or antenna pattern or far-field pattern) refers to the directional (angular) dependence of the strength of the radio waves from the antenna or other source. [1][2][3] Particularly in the fields of fiber optics, lasers, and integrated optics, the term radiation pattern may also be used ...
The Smith chart (sometimes also called Smith diagram, Mizuhashi chart (水橋チャート), Mizuhashi–Smith chart (水橋スミスチャート), [1] [2] [3] Volpert–Smith chart (Диаграмма Вольперта—Смита) [4] [5] or Mizuhashi–Volpert–Smith chart), is a graphical calculator or nomogram designed for electrical and electronics engineers specializing in radio ...
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with ...
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.