Search results
Results From The WOW.Com Content Network
Specified Minimum Yield Strength (SMYS) means the specified minimum yield strength for steel pipe manufactured in accordance with a listed specification 1. This is a common term used in the oil and gas industry for steel pipe used under the jurisdiction of the United States Department of Transportation .
Allowable Strength Design and Allowable Stress Design (ASD) are terms used by the American Institute of Steel Construction (AISC) in the 14th Edition of the Manual of Steel Construction. [ 1 ] [ 2 ]
The AWS defines welding PQR as a record of welding variables used to produce an acceptable test weldment and the results of tests conducted on the weldment to qualify a Welding Procedure Specification. For steel construction (civil engineering structures) AWS D1.1 is a widely used standard.
Structural steel welding - Welding of steel structures subject to high levels of fatigue loading AS/NZS 1554.6: Structural steel welding - Welding stainless steels for structural purposes AS/NZS 1554.7: Structural steel welding - Welding of sheet steel structures AS/NZS 3992: Pressure equipment - Welding and brazing qualification AS/NZS 4855
The American Institute of Steel Construction (AISC) is a not-for-profit technical institute and trade association for the use of structural steel in the construction industry of the United States. AISC publishes the Steel Construction Manual, an authoritative volume on steel building structure design that is referenced in all U.S. building codes.
Steel Design, or more specifically, Structural Steel Design, is an area of structural engineering used to design steel structures. These structures include schools , houses , bridges , commercial centers , tall buildings , warehouses , aircraft , ships and stadiums .
Steel is used extremely widely in all types of structures, due to its relatively low cost, high strength-to-weight ratio and speed of construction. Steel is a ductile material, which will behave elastically until it reaches yield (point 2 on the stress–strain curve), when it becomes plastic and will fail in a ductile manner (large strains, or ...
A clear distinction is made between the ultimate state (US) and the ultimate limit state (ULS). The Ultimate State is a physical situation that involves either excessive deformations leading and approaching collapse of the component under consideration or the structure as a whole, as relevant, or deformations exceeding pre-agreed values.