Search results
Results From The WOW.Com Content Network
Loudness compensation, or simply loudness, is a setting found on some hi-fi equipment that increases the level of the high and low frequencies. [1] This is intended to be used while listening at low-volume levels, to compensate for the fact that as the loudness of audio decreases, the ear's lower sensitivity to extreme high and low frequencies ...
The Headset Profile (HSP) connects headphones and earbuds to a cell phone or laptop. The Health Device Profile (HDP) can connect a cell phone to a digital thermometer or heart rate detector. The Video Distribution Profile (VDP) sends a video stream from a video camera to a TV screen or a recording device.
This has the additional undesirable effect of being dependent of the efficiency of the headphones; a device producing the maximum allowed power may not produce adequate volume when paired with low-efficiency, high-impedance equipment, while the same amount of power can reach dangerous levels with very efficient earphones.
Tone control is a type of equalization used to make specific pitches or frequencies in an audio signal softer or louder. It allows a listener to adjust the tone of the sound produced by an audio system to their liking, for example to compensate for inadequate bass response of loudspeakers or earphones, tonal qualities of the room, or hearing impairment.
There are however different pin-alignment to the 3.5mm plug, mainly OMTP and CTIA, so a user should find out which settings their device uses before buying a headphone/headset. Many wireless mobile headsets use Bluetooth technology, supported by many phones and computers, sometimes by connecting a Bluetooth adapter to a USB port.
In 1957 Willard Meeker developed a working model of active noise control applied to a circumaural earmuff. This headset had an active attenuation bandwidth of approximately 50–500 Hz, with a maximum attenuation of approximately 20 dB. [3] By the late 1980s the first commercially available active noise reduction headsets became available.
The first research on the topic of how the ear hears different frequencies at different levels was conducted by Fletcher and Munson in 1933. Until recently, it was common to see the term Fletcher–Munson used to refer to equal-loudness contours generally, even though a re-determination was carried out by Robinson and Dadson in 1956, which became the basis for an ISO 226 standard.
An Alesis Micro Gate noise gate. A noise gate or simply gate is an electronic device or software that is used to control the volume of an audio signal.Comparable to a limiter, which attenuates signals above a threshold, such as loud attacks from the start of musical notes, noise gates attenuate signals that register below the threshold. [1]