Ads
related to: rubber kick plates for wall mounted cabinets laundry room top load
Search results
Results From The WOW.Com Content Network
The kick space is intended to prevent potential toe injuries and allow for closer proximity to a countertop (the toes being the furthest-extending ground-level human body parts). [2] Typical dimensions are roughly 4 inches (10 cm) high by 3 inches (7.6 cm) deep. A fully enclosed cabinet base with a kick space.
Gebhard developed the dish drying cabinet in 1944 and 1945, and the Institute started manufacturing the cabinets and selling the design in 1945. These cabinets were wholly made of wood, and made only in two sizes. Enso-Gutzeit began industrial production of the cabinets in 1948, and in 1954 a rack made from plastic-coated steel wire was ...
A truss connector plate, or gang plate, is a kind of tie. Truss plates are light gauge metal plates used to connect prefabricated light frame wood trusses. They are produced by punching light gauge galvanized steel to create teeth on one side. The teeth are embedded in and hold the wooden frame components to the plate and each other.
Quartz-bearing granite (usually pink, white, or grey) is often made thicker than black granite to provide equal load-bearing capabilities of the types of material used for surface plates, as it is not as stiff as black granite. Damage to a granite surface plate will usually result in a chip but does not affect the accuracy of the overall plane.
The height of a rack can vary from a few inches, such as in a broadcast console, to a floor-mounted rack whose interior is 45 rack units (200.2 centimetres or 78.82 inches) high. 42U is a common configuration. Many wall-mounted enclosures for industrial equipment use 19-inch racks.
A slide plate is a linear bearing that may be part of the expansion joints of bridges, high temperature horizontal ducts of water-tube boilers and other mechanical or structural engineering applications. In each case one plate is fixed and the other slides on top as expansion or contraction occurs.
As an alternative to rubber plates, "technique plates", made of plastic, are available. Technique plates are more expensive than rubber, but hold up better to repeated drops. Their primary purpose is to allow novice lifters to practice Olympic lifts at lighter weights that can put too much lateral stress on single pairs of rubber plates ...
A plate nut, also known as a nut plate, anchor nut or anchor plate, is a stamped sheet metal nut that is usually riveted to a workpiece. They have a long tube that is internally threaded and a plate with two clearance holes for rivets. The most popular versions have two lugs and they exist as fixed anchor nuts [1] and as floating anchor nuts. [2]