Ad
related to: stair stringers wikipedia
Search results
Results From The WOW.Com Content Network
A stair flight is a run of stairs or steps between landings. A stairwell is a compartment extending vertically through a building in which stairs are placed. A stair hall is the stairs, landings, hallways, or other portions of the public hall through which it is necessary to pass when going from the entrance floor to the other floors of a building.
This page was last edited on 1 May 2021, at 05:46 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply ...
Stringer (aircraft), or longeron, a strip of wood or metal to which the skin of an aircraft is fastened; Stringer (slag), an inclusion, possibly leading to a defect, in cast metal; Stringer (stairs), the structural member in a stairway that supports the treads and risers; Stringer (surfing), a thin piece of wood running from nose to tail of a ...
An extension ladder. A ladder is a vertical or inclined set of rungs or steps commonly used for climbing or descending. There are two types: rigid ladders that are self-supporting or that may be leaned against a vertical surface such as a wall, and rollable ladders, such as those made of rope or aluminium, that may be hung from the top.
A stairwell or stair room is a room in a building where a stair is located, and is used to connect walkways between floors so that one can move in height. [1] Collectively, a set of stairs and a stairwell is referred to as a staircase or stairway .
In two-story construction, openings are left in the floor system for a stairwell, in which stair risers and treads are most often attached to squared faces cut into sloping stair stringers. [citation needed] Interior wall coverings in light-frame construction typically include wallboard, lath and plaster or decorative wood paneling. [citation ...
Theoretical rise and run of stringer, placement of square, marking of tread and rise, dropping the stringer, ABC=90°, total rise of stringer = 2R-T, total run of stringer = 2AB. Stairs usually consist of three components. They are the stringer, the tread and the riser. The stringer is the structural member that carries the load of the ...
The jig in the image is designed to cut only one segment of the stringer [2] at a time. Some industrial staircase jigs [3] are designed to cut out an entire stringer in one setup. There are jigs to cut dovetails, mortise & tenon joints, box joints, keyed miters, finger joints, bridle joints, scarf joints, and many other joints.