Search results
Results From The WOW.Com Content Network
The calculator was sold in a hinged mahogany case 46 by 12 by 11 centimetres (18.1 in × 4.7 in × 4.3 in) which, if required, holds the instrument when in use by means a brass support that can be latched to the outer end of the case. [6] [7] Out of its case the calculator weighs about 900 grams (32 oz). [8]
Volume was measured in ngogn (equal to 1000 cubic potrzebies), mass in blintz (equal to the mass of 1 ngogn of halva, which is "a form of pie [with] a specific gravity of 3.1416 and a specific heat of .31416"), and time in seven named units (decimal powers of the average earth rotation, equal to 1 "clarke").
A ruler, depicting two customary units of length, the centimeter and the inch. A unit of length refers to any arbitrarily chosen and accepted reference standard for measurement of length. The most common units in modern use are the metric units, used in every country globally. In the United States the U.S. customary units are also in use.
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
This is approximately 1 / 8 inch per mile; 12.7 kilometres is exactly 500,000 standard inches and exactly 499,999 survey inches. This difference is substantial when doing calculations in State Plane Coordinate Systems with coordinate values in the hundreds of thousands or millions of feet.
Two wooden yardsticks with brass ends, in inches and division of yard for half, quarter, eighth and sixteenth A folding metre-stick carpenter's ruler with millimetre divisions and numbers in centimetres. Fully extended it measures 2 metres. In countries in which the metric system is used, the scale typically contains only a metric scale.
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
In both customary and imperial units, one foot comprises 12 inches, and one yard comprises three feet. Since an international agreement in 1959, the foot is defined as equal to exactly 0.3048 meters. Historically, the "foot" was a part of many local systems of units, including the Greek, Roman, Chinese, French, and English systems. It varied in ...